Manual 3060 System - SimonsVoss technologies

LON – Network 3065
Page 18
Routers need a 230 V AC power supply from the customer (outlet).
Routers, as they come from the factory, do not have any over voltage
protection. For this reason, this protection should be already provided for by
the
customer.
If elevators are to be integrated into the networking, they are not permitted to
be installed in the backbone. Instead, they must be separated from the
backbone by a router.
6.2 Assembly Instructions
You can attach routers to a DIN rail. Please refer to the following figure for the
connection assignments:
1+2 Input A of network
3+4 Additional input A (internal bridges from 1-3 and from 2-4)
5 Not used
6+7 Supply voltage: power supply connection
8+9 Additional supply voltage (internal bridges from 6-8 and from 7-9)
10-14 Not used
15+16 Output B of network
17+18 Additional output B (internal bridges from 15-17 and from 16-18)
This output can be used for connecting the LPI-10, for example.
Connect the inputs of all routers in parallel. It is very important that you do not
confuse input A and output B with one another.