Manual 3060 System - SimonsVoss technologies

LON – Network 3065
Page 4
1.0 Introduction
In the following, we always speak of locking(s) and doors as the System 3060
components (locking cylinder, control unit, Smart Relay, shuntlock). Unless otherwise
expressly mentioned, however, this information is valid for all other System 3060
components.
Programming the System 3060 with a laptop and SmartCD is advisable up to a
certain object size or for customers with a limited number of doors, because changes
in the configuration of the lockings usually do not have to made often in this case.
For medium-sized or large objects, where it happens more often that keys are lost,
new transponders have to be approved, and there are organisational changes, there
is the possibility of caring for and maintaining the locking system via the network. This
does not necessarily mean that all doors have to be networked, however. The entire
system can also be designed for mixed operation (networking/standalone).
In a networked system, it is not only possible to take care of all maintenance and
programming task’s from one central PC, it is also possible to obtain an overview of
the current status of the entire network. For example, it is possible to check locking
and door conditions, such as door open/door closed and door locked, and to display
battery warnings, the access journal and burglar alarms from a central location. This
makes it possible to react to an event directly from the control center.
In summary, it can be stated that using networking, it is possible to configure and
monitor the entire access control system from one central PC. This means that the
user can react to critical conditions in a short time.