Manual 3060 System - SimonsVoss technologies

Smart Relay: SREL, SREL.ZK, SREL.ADV
Page 8
5.0 Installation
Switch off the supply voltage (if necessary, pull out the plug or disconnect the
battery).
Connect all cables to the terminals provided on the Smart Relay (see
Connection Assignments on the following page)
If you are connecting a direct current power supply, make sure that you
get the polarity right.
You can attain the largest reader range if you align the Smart Relay antennas
so that they are parallel to that on the transponder during the installation.
Switch on the supply voltage (if necessary, insert the plug or connect the
battery).
Verify the function of the Smart Relay with a transponder in the condition as
received from the factory.
Program the Smart Relay with the SimonsVoss software (we recommend
software version LDB.EXE 1.40 or later).
Use a transponder that is now authorised in order to test the functioning of the
Smart Relay again.