Manual 3060 System - SimonsVoss technologies

Manual – Digital Half Cylinder 3061
Page 20
Batteries
Recessed grip
ring
Knob
Markings
8. Replace the knob (according to the triangular markings, see drawing), hold the recessed
grip ring and turn the inner knob (approx. 10°) in a clockwise direction to
tighten.
9. Slide the recessed grip ring back onto the knob so that the knob and ring are flush
against each other.
10. Hold the assembly/battery tool against the knob so that both nibs fit into the openings
on the ratchet disk (if necessary turn the knob until the nibs slot into the openings).
11. Lock the knob by turning it approx. 30° in a clockwise direction (until you hear a
clicking noise).
Use an authorised transponder to check functionality.
When replacing the batteries on a ZK version you may have to reset the
time as the clock will stop running when the power supply is interrupted
(software operating instructions: Programming Set locking clock time).