Manual 3060 System - SimonsVoss technologies

Manual – Digital Half Cylinder 3061
Page 5
1.2 Product description
Higher security, greater flexibility, lower cost, network-capability without any wiring in
doors and frames, low installation effort - all this is possible right now with the digital
locking cylinder 3061. The outer dimensions of the digital locking cylinder are exactly
the same as those of DIN 18254 and EN 1303; retrofitting to standard doors and locks,
key-operated switches, etc., is possible at any time. It is quick and easy to exchange.
Adding new functionality to the locking cylinder's scope is made possible by upgradeable
firmware. Your investment is thus protected, as "retrofitting" new functions is an
uncomplicated matter.
The System 3060 has a modular design that makes it easy to install further cylinders to
subsequent extensions and to manage them online as a wireless network. An integrated
voltage supply makes cylinder operation self-sufficient and independent from a
mains power supply. There is no need for any wiring whatsoever.
All system components are fully integratable with the SimonsVoss System 3060 due to
system modularity; every SimonsVoss component is programmable using the locking
plan software.
1.3 Design
Actuator Electronics Batteries Knob
1.4 Opening and closing
The knob rotates freely when deactivated. It is not possible to open or close the door or
to control a key-operated switch. Hold the transponder approximately 10 to 40 cm from
the digital half cylinder and briefly press the transponder button. If you are using an
authorised transponder the half cylinder will emit a short double signal tone and subsequently
engage. Turn the knob in the appropriate direction to lock or open the door.