Manual 3060 System - SimonsVoss technologies

Digital Locking System 3060
Page 5
cylinder, Smart Relay or activation unit.
2.6 Network 3065
The cable-free Network 3065 is an online access control system that administers,
visualises and archives all System 3060 information in one central location, and all
without manipulations at the door, door frame or the door hardware.
It is especially recommended for medium-sized and large locking systems in order to
be able to configure and administer the locking system from a central PC. The LON
standard data transmission is done from the PC over the network wiring (twisted pair)
and out to the network nodes (LockNodes), which are installed near a digital
component. From the LockNode, the data is directed without wires over radio
transmission to the digital unit.
☺
While it is true that access to the network software is no longer possible if
there is a power failure (unless the network has been protected by a no-break
power supply), however, all of the locking system’s components that are
equipped with a battery still function.
2.7 Block Lock Function 3066
SimonsVoss has the Block Lock Function 3066 in its product line as an option of the
Digital Locking and Organization System. This function offers the possibility of
activating your alarm system from a central point while at the same time preventing
the monitored doors from being accidentally opened during this time. This rules out
annoying and expensive false alarms right from the start.
The Block Lock Function 3066 is also available as a VdS version.
3.0 Digital Components With Access Logging and
Time Zone Control
3.1 Access Logging
The Plus versions of the digital locking cylinder, SmartRelay and activation unit record
the access attempts of authorised transponders. The read-out of the access list from
the lockings is done using the SmartCD or, in the case of a networked locking
system, over the LockNodes.
A total till 128 accesses (with Smart Relay 1.024), with date, time of day and
transponder designation can be stored in the access lists of the separate
components. After that, the complete file isn’t deleted, but instead the oldest access is
always overwritten with the new one.