Manual 3060 System - SimonsVoss technologies

Manual – Digital locking cylinder 3061
Page 19
Replace the knob and rotate it anti-clockwise under light pressure until the external
knob fits into the recesses on the flange. If necessary, push the knob in this position
towards the profile cylinder housing.
Caution: rotating the bayonet disk when not installed can prevent the knob
from fitting correctly. In this case use the assembly tool to turn the bayonet
disk back to the original "bayonet disk open" position. (See illustrations)
Bayonet disk
Knob
Bayonet disk closed
Bayonet disk open
Hold the assembly tool so that the two nibs fit into the external knob (if
necessary, turn the knob until the two nibs hook into the recesses). Rotate
the knob clockwise by 30° to close it again.
5.3.4 Perform a function test
1. Engage the locking cylinder using the transponder; with the door open,
rotate the knob in both directions for opening and locking. The knob
should rotate easily in both directions.
2. Close the door and repeat the test. If the knob is difficult to rotate you
will need to adjust the door or the striking plate.