USER MANUAL FOR F.I.O. INSTALLATION - Pietro Fiorentini

7.1.2.3 Alarm
In the general page “Alarm” clicking on “Show
Log” it is possible to see all the status changes
of the alarms stored in the ECU.
In the page related to the variable to be
monitored, clicking on “Modify” it is possible to
select 3 alarm levels for high limit (“High, “High
High” and “Fault High”) and 3 alarm levels of low
limit (“Low, “Low Low” and “Fault Low”). It is also
possible to set a value of maximum excursion of
the variable (“Max range”).
Each intervention can be monitored as an event,
selecting it on “Event enable” (it is only recorded
in the memory of the ECU) or as an alarm,
selecting it on “Alarm enable” (in this case it is
generated also an SMS).
Finally, it is possible to display the current status
of the thresholds.
F.I.O.
User’s Manual
Modify
ENGLISH
F.I.O. User Manual – Ed.2. Rev.5 Page 30/ 53
The information contained in this document is confidential and the property of Pietro Fiorentini S.p.A.
Technical data may undergo changes without notice
Show Log