Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>nRF24LU1</strong> <strong>Development</strong> <strong>Kit</strong> <strong>User</strong> <strong>Guide</strong><br />
4.1.1 Basic setup<br />
The Basic setup is used to run the <strong>nRF24LU1</strong> trough a set of predefined modes, ideal to use when<br />
preparing for EMC testing.<br />
Figure 2: Basic Feature Board with <strong>nRF24LU1</strong> Radio Module connected to USB cable<br />
To use the CES firmware in stand alone mode, follow these steps:<br />
1. Connect the Basic Feature Board with the <strong>nRF24LU1</strong> Radio Module in place, as configured<br />
earlier, to a USB connector on the PC.<br />
2. Start Notepad on the PC. Make sure that the Notepad Window is the active Window as long<br />
as you run the test.<br />
3. Press “Num Lock”<br />
The following screen will appear:<br />
Figure 3 – CES Stand Alone startup screen<br />
Revision 1.0 Page 8 of 36
Change language