Direct Material Supplies Quality Agreement - Arçelik

Direct Material Supplies Quality Agreement
Records relating to the implementation of control plans shall be maintained. Control plans shall be
revised in line with information, i.e. Arçelik feedback, process controls, etc.
3.4. Product identification and traceability
The Supplier shall identify the material by proper means at the product realization stage. The
Supplier shall identify material status according to monitoring and measurement specifications. In
manifest situations, product location identification will be adequate in the automated production
transfer process. Changes in material and production specifications shall be recorded.
3.5. Arçelik property
The Supplier shall pay due care to Arçelik property as long as such property is under the control of,
or used by the Supplier. The Supplier shall identify, verify, protect and secure the safety of
customer property provided for use, or for incorporation in the manufacture of a product. Unless
otherwise approved in writing by Arçelik, all dies, benches, raw materials, substances, products,
semi-finished products, etc. which are the property of Arçelik may only be used for the production
of products or services for Arçelik. Arçelik shall be notified of any Arçelik property lost, damaged or
found in unusable condition; and records thereof shall be maintained.
Unless otherwise notified in writing by Arçelik, insurance policies for the materials and equipment
which are the property of Arçelik and kept at the Supplier’s premises shall be taken out by Arçelik.
Returnable packages which are the property of Arçelik are subject to this article.
3.6. Procurement process
The Supplier shall ensure that the product purchased by the Supplier complies with the identified
purchasing specifications. Type and content of the control applicable to the Supplier and the
purchased product shall depend on the impact of the purchased product on the subsequent
product realization, or on the end product.
Employment of the sources identified by Arçelik shall not release the Supplier from its responsibility
to ensure the quality of purchased products.
3.7. Change control
The Supplier shall notify Arçelik of all product realization changes with an impact on Arçelik
specifications and obtain Arçelik’s approval.
The following changes shall be verified for validity before implementation:
Production method and parameter change (production and control cycle change),
Design change,
Material change,
Supplier change,
Change in test equipment and methods,
Change in the location of production equipment at the same premise,
Re-commissioning of equipment and line which have not been operational for more than
one year,
Technical specification change.
4 / 17 F. Code:933180