Ultra-thin Split Unit - Lomax

Maintenance
◆
Warning
Maintenance
▲Turn off the unit and pull out the power plug before cleaning the unit, otherwise
electric shock may occur.
▲Do not make the unit wet, or electric shock may occur. Ensure that the unit
would not be washed by water under any circumstance.
▲Volatile liquid like thinner or gasoline would damage the appearance of the unit
(only adopts soft dry cloth and wet cloth moisted with neuture cleaning fluid to
clean appearance of the unit).
Disassemble and wash of filter
1. Lift the panel by hand according to arrow direction;
2. Pull down panel by arrow direction;
3. Uplift the panel a little by arrow direction 1, then take
out filter by arrow direction 2. Adopt cleaner or water
to wash filter, if the filter is too dirty (like oil spot), wash
it by warm water (lower than 45℃) melted with neutral
cleaning fluid then dry it in shade.
Installation of filter
1. Uplift the panel a little by arrow direction 1, then insert
the filter from nether of the panel by arrow direction 2.
2. Uplift the panel by arrow direction to the location shown
as figure.
3. Insert the clamp A, B and C to the 3 rotating shaft by
arrow direction and cover panel.
19