Ultra-thin Split Unit - Lomax
Ultra-thin Split Unit - Lomax
Ultra-thin Split Unit - Lomax
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Installation<br />
☆ Electric wiring<br />
1. Open the panel upwards;<br />
2. Disassemble the fixing bolts of wiring cover,<br />
as shown in right figure;<br />
3. Lead power connect cord though rear of<br />
button case from down to up;<br />
terminal, yellow-green wire (i.e. earth wire) onto "<br />
electric box.<br />
Power connect cord of<br />
indoor and outdoor unit<br />
4. Connect blue wire in power connect wire onto "N(1)" terminal, brown wire onto "2"<br />
" terminal (as shownin fig.3);<br />
and press the power connect cord by wire clamp that in front of line bank on<br />
5. To heat pump type unit, signal control cord connect with indoor unit through connector<br />
as (shown in fig.3), and tighten the control cord by clamp on bottom of case.<br />
6. Install the cover plate on its original and tighten screws.<br />
Wiring cover<br />
Line bank<br />
Brown<br />
Wire<br />
clamp<br />
Power connect cord<br />
Fig. 3<br />
14