Ultra-thin Split Unit - Lomax

More documents

Recommendations

Info

Installation Install Dimension Diagram 15cm or more Distance to ceiling 15cm or more Distance to wall Distance to wall 15cm or more 300cm or more Exhaust side 230cm or Distance to floor more Important Advance ★ To ensure better usage, please have the installation done by professional personnel by following this manual. ★ Please contact the local service center before installation. Malfunction caused by installation by unauthorized unit may be hard to solve for inconvenient business contact. ★ When moving the units, it is better to be guided by professional personnel. 50cm or more Distance to shelter Air in side 30cm or more Distance to wall 30cm or more 50cm or more Distance to wall 200cm or more Exhaust side 11
Installation ◆ Installation of Indoor <strong>Unit</strong> ☆• Install the Rear Panel 1. Measure horizon by hanging line or horizontal measurement. Since drainage hole is at left side, it is better to adjust left side little lower. Fig. 1 2. Fix rear panel on wall by bolts. 3. Pull the panel by hand after installation to see if it is firm enough. The rear panel should be able to stand the weight of an adult (60kg). And the weight should be evenly shared each screw. ☆ Install the Piping Hole 1. After determined pipe hole location as fig.1, drill a hole (φ90) slant downward. 2. In order to protect pipe and cable from damaging when going though wall, put on wall pipe. ☆ Install the Drainage Hose 1. For well draining, the drainage hose shoule be placed at a downward slant. Wrench Bend 2. Do not wrench, bend or heave the drainage hose Don't flood it or flood its end in water. in water 3. The prolonged drainage hose should be wrapped with insulation material when passing through indoor. ☆ Install the Indoor <strong>Unit</strong> 1. Refer fig.a for piping mode of indoor unit. When piping (wiring) at left side, cut off tailings from pipe left from chassis of host (as shown in fig.4(b)). (1) Cut off tailing 1 when only power cord is led; (2) Cut off tailing 1 and 2 when connect pipe and wire are led; Piping mode 1 is recommended. 12
Page 1 and 2: C GREE SY/AZ Install Unit: Tel: GRE
Page 3 and 4: Structure Principle and Usage ◆ S
Page 5 and 6: Structure Principle and Usage ★ E
Page 7 and 8: Structure Principle and Usage Usage
Page 9 and 10: Structure Principle and Usage ◆ O
Page 11: Installation Wiring Collocation 1.
Page 15 and 16: Installation ☆ Electric wiring 1.
Page 17 and 18: 6. Rotate tightening plate and pres
Page 19 and 20: Installation ☆ Check after Instal
Page 21 and 22: Maintenance Check before use 1. Che
Page 23 and 24: Maintenance Stop the unit from runn

Ultra-thin Split Unit - Lomax

Create successful ePaper yourself

Delete template?

Save as template?