Safety Manager Safety Manual - Tuv-fs.com

5 – Special requirements for TUV-approved applications
4. The field instruments, including panel instruments such as (key) switches,
which are used in conjunction with Safety Manager, must meet the
requirements of the applicable parts of the EN-54 standard. Visual and audible
indications shall be as defined in paragraph 3.2 of EN-54 part 2.
5. Field inputs must have loop-monitoring to detect short-circuits and open
loops. Input module types that can be used are: SAI-0410, SAI-1620m and
SDIL-1608.
Field outputs must also have loop-monitoring. Output module type that can be
used: SDOL-0424.
6. The Fire & Gas detection system shall have earth leakage
monitoring/detection facilities.
7. Remote display of alarms, failures etc. may only be given via interconnection
of Safety Manager systems using the communication option between Safety
Manager systems or via hard wired outputs with loop-monitoring via the
SDOL-0424 digital output modules. Communication and loop monitoring
failures must be alarmed.
8. Safety Manager is only the basis for an EN-54 compliant application. The
responsibility for a full EN-54 compliant application lies with the person(s)
responsible for configuring and application programming of Safety Manager.
The requirements of EN-54 which must be met by the application can be
found in section 9, which references the requirements that must be fulfilled in
the application.
9. For details on the requirements of the mechanical construction (cabinet,
indications, horns) refer to “EN-54 part 2 paragraph 3.2.”
52 Release 131, Issue 4.2