Safety Manager Safety Manual - Tuv-fs.com

2 – Architectural principle and standards of Safety Manager
UL 991
Test for safety-related controls
employing solid-state devices,
second edition.
FM3600, FM 3611 Electrical equipment for use in
Class I, Division 2, • Class I, Division 2,
Groups A, B, C &
• Class II, Division 2, and
D
• Class III, Division 1 and 2,
Class II,
hazardous locations.
Division 2,
Groups F & G
CSA C22.2
IEC 60068-1
Table 3 Safety Manager compliance to standards
Standard Title Remarks
Process control equipment.
Industrial products.
Basic environmental testing
procedures.
Underwriters Laboratories.
Factory Mutual Research.
Applies to the field wiring
circuits of the following
modules:
SDI-1624, SAI-0410,
SAI-1620m, SDIL-1608 and
SAO-0220m, and installation of
the Controller in these
environments.
Canadian Standards Association
No. 142 (R1993).
IEC 60068-2-1 Cold test. 0°C (32°F); 16 hours; system in
operation; reduced power supply
voltage:
(–15%): U=20.4 Vdc or
(–10%): U=198 Vac.
IEC 60068-2-1 Cold test. –10°C (14°F); 16 hours; system
in operation.
IEC 60068-2-2 Dry heat test. up to 65°C (149°F); 16 hours;
system in operation; increased
power supply voltage:
(+15%): U=27.6 Vdc or
(+10%): U=242 Vac.
IEC 60068-2-3 Test Ca: damp heat, steady state. 21 days at +40°C (104°F), 93%
relative humidity; function test
after cooling.
IEC 60068-2-3 Test Ca: damp heat, steady state. 96 hours at +40°C (104°F), 93%
relative humidity; system in
operation.
IEC 60068-2-14 Test Na: change of temperature –
withstand test.
–25°C—+55°C (–13°F—
+131°F), 12 hours, 95% relative
humidity, recovery time: max. 2
hours.
16 Release 131, Issue 4.2