Owner's Manual - Roland

System Settings
Rx
Rx Sync
Rx Pitch
Bend
Rx
Program
Change
OFF, ON
OFF, ON
OFF, ON
OFF, ON
SYSTEM METRONOME
Refer to “MIDI Parameters” (p. 44).
Parameter Value Explanation
Metronome
Switch*
Metronome
Mode
OFF, ON
ALWAYS,
REC,
PLAY
Refer to “Using the Metronome” (p.
23).
Viewing Information about GW-8
(System Version Info Screens)
Here’s how to view information about the GW-8 such as its
software version.
1. Press [MENU].
2. Use [ ] [ ] to select “Version” then press [ENTER].
3. Use [ ] [ ] to select a page.
You can view information about the imported Special
Tones as well as the version of software used by the
GW-8.
4. Press [EXIT] to return to the Main screen.
Metronome
Level
LOW,
MEDIUM,
HIGH
SYSTEM LOCK
Parameter Value Explanation
Style
Tone
Style
Tempo
Rx
Modulation
Transpose
OFF, ON
OFF, ON
OFF, ON
OFF, ON
Refer to “Preserving Certain
Settings Even When You Switch
Performances ([LOCK])” (p. 16).
MASTER EQ settings (p. 37) are stored in System settings.
Settings cannot be stored for the parameters marked by “*” in
the table. When the power is turned on, these parameter will
always return to the same value (the default value).
System settings that are not stored
In addition to the parameters marked by “*” in the above
table, the following settings cannot be stored.
• BALANCE button setting (p. 24)
• Recording setting (p. 28)
Rec Mode/Count In/Punch In/Out setting/Input Quantize
• D Beam controller on/off (p. 34)
• LOCK button on/off (p. 16)
• ANALOG MODIFY SELECT button setting (p. 37)
• External input Center Cancel (p. 17)
• MINUS ONE/CENTER CANCEL button on/off (p. 30, p. 32)
48