Autel Maxiscan Jp701 Manual.pdf - Car Diagnostic Tool

8) Press OK button to erase recorded data, and a “Delete done!”
message shows on the screen.
• If you decide not to delete the data, press Back button to
return to previous screen.
5. Diagnostics
5.1 OBDII/EOBD Diagnostics
When more than one vehicle control module is detected by the
scan tool, you will be prompted to select the module where the
data may be retrieved. The most often selected modules are
Powertrain Control Module [PCM] and Transmission Control
Module [TCM].
1) Turn the ignition off.
2) Locate the vehicle’s 16-pin Data Link Connector (DLC).
3) Plug the OBDII connector to the vehicle’s DLC.
4) Turn the ignition on. Engine can be off or running.
5) Use UP/DOWN button to select OBDII/EOBD from Main Menu.
Main Menu
►OBDII/EOBD
Honda
Toyota
Review Data
Self-Test
System Setup
OK
6) Press OK button to confirm. A sequence of messages displaying
protocols will be observed on the display until the vehicle protocol
is detected.
29