Autel Maxiscan Jp701 Manual.pdf - Car Diagnostic Tool

5) “ ” -- Scroll bar indicates additional information is available on
previous or next screens.
3.5 Power
Internal Battery Power
The scan tool has four 1.5V batteries that provide power for off-car
review and analysis. Press power key to turn on the scan tool.
When the “ ” icon flashes, replace the battery as instructed in
“Battery Replacement” on paragraph 3.9.
• If the scan tool is stored for a long period of time, remove
batteries to prevent battery leakage from damaging battery
compartment.
External Power
External power of the scan tool is provided via the vehicle Data Link
Connector (DLC). Just follow the steps below to turn on the scan tool:
1) Connect the scan tool and diagnostic connector with the
extension cable supplied.
2) Find DLC on vehicle.
• A plastic DLC cover may be found for some vehicles and you
need to remove it before plugging the OBD2 cable.
3) Plug the diagnostic connector to vehicle’s DLC.
3.6 Obtaining Login Password
CAUTION: The login password is used to get access to software
updates and technical supports from manufacturer or distributors’
websites. DO NOT read the password unless you decide to buy the
scan tool.
1) Install four 1.5V batteries and press power key, or connect
the tool to vehicle DLC to power up the scan tool.
2) From Main Menu, use UP/DOWN button to select Login
Password, and press OK button.
11