March 4, 2013 - Cabarrus County

Above the door there shall be a cabinet with storage for (3) glove boxes. There shall be openings in the
cabinet door for dispensing of the gloves.
Does your bid comply?
Yes __X__ No_____
Front Wall Walk-Through
There shall be a walk through between the driver's and patient compartment. For the Type I the cab roof must
be raised by the installation of a “bubble” fabricated for that purpose in order to provide increased headroom
for egress.
Does your bid comply?
Yes __X__ No_____
Insulation
The entire ambulance body, sides, ends, and roof of the patient's compartment shall be insulated to meet or
enhance the environmental criteria specified in Federal Specifications KKK-A-1822. The walls shall be insulated
with 1.875” block poly Styrofoam. There shall be 3.5" inch, R11 fiberglass batting in the roof and along the
exterior roof and corner extrusions. There shall be 3/8” foil backed foam insulation installed around the
perimeter of the A/C – Heater evaporator units, walls and ceiling in addition. The 3/8” foil backed material
shall be utilized in areas where the harnesses and block foam are in conflict. There shall be no voids in the wall
insulation process. There shall be an acoustical matting installed above the wheel well liners, in the floor, and
on the exterior compartments on the sides towards the module interior. This material shall also be installed on
the back sides of the interior aluminum cabinetry. The sub-floor shall be insulated with spray in foam
insulation for acoustical and environmental insulation. The doors shall be insulated with at least 1.875" of
plank foam. This insulation shall not interfere with the workings of the door latching hardware.
Does your bid comply?
Yes __X__ No_____
Patient Compartment Sound Level
Sound levels within the patient compartment shall not exceed eighty (80) decibels in accordance with AMD
Standard 006.
Does your bid comply?
Yes __X__ No_____
50
Attachment number 1
4-4
Page 84