March 4, 2013 - Cabarrus County

Dimensions given here are applicable to the Type III ambulance. For the Type I, the dimensions may be altered
as required to accommodate the chassis differences, but must be as near as possible to the requested
dimensions.
Street side Compartments (three (3) total):
1 - O2 compartment location front 20 ½”W x 80 ”H x 18 ¾”D. There shall be a vent with a cast cover located on
the door. There shall be a Zico electric oxygen cylinder lift installed inside.
2 – In front of rear wheel well 38” W x 36 ¼” H x 18 ¾” D; one (1) adjustable shelf shall be installed.
4 – Rear compartment 28” W x 36 ”H x 18 ¾”D. There shall be one (1) adjustable shelf installed.
Curb side Compartments (four (4) total):
5 - Back board compartment at the rear, 16”W x 80 ¾”H x 20”D with one (1) fixed vertical divider extending
downward from the ceiling 37”, located 8 ¼” from the front of the compartment. There shall be one (1) fixed
shelf with ½” lip extending from the front of the compartment to the vertical divider.
6 - Next to backboard compartment behind rear wheel 19”W x 24 ¾”H x 18 ¾” D.
8 – ALS compartment outside dimensions 22 ½”W x 57 ½”H x 32 ½”D. This will have inside/outside access. In
the center there shall be a drawer the full width of the cabinet and approximately 9” deep, accessible only
from the inside of the module, with a locking latch. Above and below the drawer, with inside/outside access,
shall be 2 cabinets of approximately equal dimensions. Each shall have one (1) adjustable shelf. The openings
on the inside shall be covered with split hinged Plexiglas doors.
9 - Front below ALS compartment, 22”W x 12H x 20 ¾”. This compartment is to house the vehicle’s batteries
securely mounted in a roll out tray. This compartment shall be appropriately vented to the exterior
underneath the truck.
47
Attachment number 1
4-4
Page 81