March 4, 2013 - Cabarrus County
March 4, 2013 - Cabarrus County March 4, 2013 - Cabarrus County
wired to the engine block heater through a switch to be located in the electrical compartment. It shall also be wired to a 115 Volt Broan 1000 watt minimum, with internal thermostat, which shall be installed in the face of the squad bench at the head end. There is to be a light and buzzer alarm system which shall sound and light up when the shoreline is connected and the ignition turned on. This wiring shall comply with AMD Standard 009. Does your bid comply? Yes __X__ No_____ Rear Control Switch Panel All switches and controls for the patient compartment including those for the heat and air units shall be located on a service panel in the action area. These switches shall be of the same design and construction as found on the front control switch panel. The panel shall be connected to the electronic control module by a computer cable. The panel shall include but not be limited to, controls for patient compartment dome lights, fluorescent lights, action area light, vacuum system, electric oxygen solenoid, three-light silent intercom, and three spare switches for future use. The switch for the vacuum system must be red in color as opposed to all the rest being standard black. These switches shall not be activated unless the "MASTER" switch on the front control switch panel is in the "ON" position. There shall also be a digital 12/24 hour clock with a timer function incorporated into the rear switch panel. Does your bid comply? Yes __X__ No_____ Marking of Switches, Indicators and Control Devices All switches, indicators and control devices supplied by the ambulance manufacturer shall employ permanently engraved translucent labels. Backlighting shall be activated when the "MASTER" switch is on. Decals or other "stick on" type labels are NOT ACCEPTABLE. Does your bid comply? Yes __X__ No_____ Door Open Warning Module All door open warning switches will be wired through individual circuits directly to a solid-state LED diagnostic board. There will be individual circuit connections with individual LED circuit indicators for identifying switch or circuit failures. This module will be located in the ECC. An audible alarm will be mounted in the front 32 Attachment number 1 4-4 Page 66
control console and will be an integral part of the electrical conversion system. The audible alarm will be activated when any exterior compartment or entry door is open. The alarm will be bypassed when the emergency brake is set and will automatically reactivate when the brake is released. Does your bid comply? Yes __X__ No_____ VEHICLE LIGHTING REQUIREMENTS Vehicle Exterior Lighting The basic exterior ambulance lighting shall comply to FMVSS Standard No. 108 and the requirements therein and include: amber front and red rear directional signals and hazard warning lights, front and rear side marker lights, backup light(s), loading light(s), clearance lamps, ambulance emergency lights, floodlights and scene light(s). The side marker lights will be located on the sides of the rear vertical extrusions, shall be Optronics LED lights which also function as a turn signal indicator as described in Federal Specification KKK-A-1822F. The upper I.C.C. lighting will include five (5) front amber Optronics LED, five (5) rear red Optronics LED. Does your bid comply? Yes __X__ No_____ Vehicle Emergency Lighting Systems The emergency lighting system must provide the vehicle with 360 degrees of visual warning conspicuity. The system must display highly perceptible and attention-getting signals that function in a mode system and convey the message in the PRIMARY MODE - "Clear the Right-of-Way” and the SECONDARY MODE - Hazard Vehicle stopped on Right-of Way. A switch on the front control console through the electronic control module shall control Primary/Secondary mode. All screws, bolts, inserts or other devices used to mount external lighting fixtures will be insulated with nylon inserts to prevent oxidation, corrosion or electrolysis. Does your bid comply? Yes __X__ No_____ 33 Attachment number 1 4-4 Page 67
- Page 15 and 16: No COUNTY MANAGER’S RECOMMENDATIO
- Page 17 and 18: FRIDAY, JANUARY 18, 2013, 3:00 PM S
- Page 19 and 20: CABARRUS COUNTY BOARD OF COMMISSION
- Page 21 and 22: Cabarrus County Budget Amendment Re
- Page 23 and 24: North Carolina Department of Transp
- Page 25 and 26: Based on the Revised Summary Sheet
- Page 27 and 28: CABARRUS COUNTY BOARD OF COMMISSION
- Page 29 and 30: Cabarrus County Budget Amendment Re
- Page 31 and 32: Section II. A. Special appropriatio
- Page 33 and 34: CABARRUS COUNTY BOARD OF COMMISSION
- Page 35 and 36: Specifications for a Type 1 (conven
- Page 37 and 38: When submitting their Bid Proposal,
- Page 39 and 40: Scope This specification covers a n
- Page 41 and 42: Does your bid comply? Yes __X__ No_
- Page 43 and 44: All bid prices and conditions must
- Page 45 and 46: The term "heavy-duty" as used to de
- Page 47 and 48: Front Suspension - front independen
- Page 49 and 50: Trailer tow hooks - front (2) Wheel
- Page 51 and 52: ventilated with clean air. The syst
- Page 53 and 54: Engine High-Idle Speed Control, Aut
- Page 55 and 56: Does your bid comply? Yes __X__ No_
- Page 57 and 58: Mud Flaps In order to provide addit
- Page 59 and 60: Driver's Compartment Controls The F
- Page 61 and 62: Does your bid comply? Yes __X__ No_
- Page 63 and 64: Circuit Connections Circuit connect
- Page 65: Does your bid comply? Yes __X__ No_
- Page 69 and 70: Each compartment and module entry d
- Page 71 and 72: There shall be provided a clear LED
- Page 73 and 74: The vertical corner posts and the r
- Page 75 and 76: Does your bid comply? Yes __X__ No_
- Page 77 and 78: Side Window There shall be a fixed
- Page 79 and 80: (Q). Each compartment door shall ha
- Page 81 and 82: Dimensions given here are applicabl
- Page 83 and 84: Floor The sub floor of module body
- Page 85 and 86: Patient Compartment Carbon Monoxide
- Page 87 and 88: eak angles and locations to be pre-
- Page 89 and 90: Cabinet Layout See drawings accompa
- Page 91 and 92: controlled by a low voltage switch
- Page 93 and 94: Two (2) 100-watt Cast SA4319 speake
- Page 95 and 96: of F3963 and F3964 etch primer. The
- Page 97 and 98: CABARRUS COUNTY BOARD OF COMMISSION
- Page 99 and 100: EXTRACT FROM MINUTES OF PUBLIC HEAR
- Page 101 and 102: EXTRACT FROM MINUTES OF MEETING BOA
- Page 103 and 104: the aggregate principal amount of t
- Page 105 and 106: date for such interest, pursuant to
- Page 107 and 108: Section 6. following form: The Bond
- Page 109 and 110: of any Bond to be redeemed shall be
- Page 111 and 112: [The following four paragraphs are
- Page 113 and 114: The Bond Registrar shall not be req
- Page 115 and 116: ASSIGNMENT FOR VALUE RECEIVED the u
control console and will be an integral part of the electrical conversion system. The audible alarm will be<br />
activated when any exterior compartment or entry door is open.<br />
The alarm will be bypassed when the emergency brake is set and will automatically reactivate when the brake<br />
is released.<br />
Does your bid comply?<br />
Yes __X__ No_____<br />
VEHICLE LIGHTING REQUIREMENTS<br />
Vehicle Exterior Lighting<br />
The basic exterior ambulance lighting shall comply to FMVSS Standard No. 108 and the requirements therein<br />
and include: amber front and red rear directional signals and hazard warning lights, front and rear side marker<br />
lights, backup light(s), loading light(s), clearance lamps, ambulance emergency lights, floodlights and scene<br />
light(s). The side marker lights will be located on the sides of the rear vertical extrusions, shall be Optronics<br />
LED lights which also function as a turn signal indicator as described in Federal Specification KKK-A-1822F. The<br />
upper I.C.C. lighting will include five (5) front amber Optronics LED, five (5) rear red Optronics LED.<br />
Does your bid comply?<br />
Yes __X__ No_____<br />
Vehicle Emergency Lighting Systems<br />
The emergency lighting system must provide the vehicle with 360 degrees of visual warning conspicuity. The<br />
system must display highly perceptible and attention-getting signals that function in a mode system and<br />
convey the message in the PRIMARY MODE - "Clear the Right-of-Way” and the SECONDARY MODE - Hazard<br />
Vehicle stopped on Right-of Way. A switch on the front control console through the electronic control module<br />
shall control Primary/Secondary mode. All screws, bolts, inserts or other devices used to mount external<br />
lighting fixtures will be insulated with nylon inserts to prevent oxidation, corrosion or electrolysis.<br />
Does your bid comply?<br />
Yes __X__ No_____<br />
33<br />
Attachment number 1<br />
4-4<br />
Page 67