March 4, 2013 - Cabarrus County
March 4, 2013 - Cabarrus County March 4, 2013 - Cabarrus County
Electrical The vehicle shall be supplied with three (3) “No-Maintenance” 12-volt batteries. They shall be standard OEM Heavy Duty Batteries with total capacity of no less than 2250 CCA. The batteries shall be mounted in a roll out battery tray at the lower front of the module on the curbside. There shall be no battery disconnect switches or devices installed that in any way cut-off power to the chassis. Any battery disconnect devices may interrupt power to the ambulance module only. Does your bid comply? Yes __X__ No_____ Electrical Generating System: The ambulance shall be equipped with the OEM manufacturer’s Ambulance Prep Alternator Package. Does your bid comply? Yes __X__ No_____ Engine and Transmission Engine size shall be a 6.6 liter DuraMax diesel turbocharged engine for the Type III; it shall be a 6.7 liter diesel turbocharged engine for the Type I. Transmission shall be the OEM automatic transmission supplied with the ambulance prep package. Does your bid comply? Yes __X__ No_____ Engine Block Heater The chassis shall have an OEM engine block heater. Block heater will connect to the shoreline through a switch located in the main electrical cabinet. Does your bid comply? Yes __X__ No_____ 18 Attachment number 1 4-4 Page 52
Engine High-Idle Speed Control, Automatic The vehicle shall be equipped with a high idle system. The device shall operate only when the transmission is in "Neutral" or "Park", and the parking brake has been engaged. The device shall disengage when the operator depresses the service brake pedal, the transmission is placed in gear, or parking brake is disengaged and automatically re-engages when the service brake is released, when the transmission is placed in neutral or park, and the parking brake is re-engaged. Does your bid comply? Yes __X__ No_____ Exhaust System The exhaust system shall be the OEM manufacturer's standard. There shall be galvanized heat shields above the exhaust system in accordance with Ford’s QVM. The heat shields must be a minimum of 16-gauge material for additional strength and to prevent rattling. Does your bid comply? Yes __X__ No_____ Fuel Tank/Diesel Exhaust Fluid Tank The vehicle shall be equipped with a single fuel tank, having a capacity of at least 57 gallons for the Type III and 40 gallons for the Type I. There shall be a cast aluminum fill mounted and sealed to the ambulance body, with a brushed stainless steel paint protection plate extending from the fill downward to the bottom of the body or top of the rub rail. This plate shall be securely adhered and sealed to the surface of the body, not fastened with rivets or screws. The Diesel Exhaust Fluid tank shall not be modified from OEM standards in any way, including the location of the fill or hoses. There shall be a cast aluminum fill mounted and sealed to the ambulance body, with a brushed stainless steel paint protection plate extending from the fill downward to the bottom of the body or top of the rub rail. This plate shall be securely adhered and sealed to the surface of the body, not fastened with rivets or screws. Does your bid comply? Yes __X__ No_____ 19 Attachment number 1 4-4 Page 53
- Page 1 and 2: CABARRUS COUNTY BOARD OF COMMISSION
- Page 3 and 4: ATTACHMENTS QSCB Project Status Rep
- Page 5 and 6: School Project Description Total Or
- Page 7 and 8: CABARRUS COUNTY BOARD OF COMMISSION
- Page 9 and 10: Cabarrus County Facility Data 11 Ad
- Page 11 and 12: Weaknesses of Facilities in Cabarru
- Page 13 and 14: CABARRUS COUNTY BOARD OF COMMISSION
- Page 15 and 16: No COUNTY MANAGER’S RECOMMENDATIO
- Page 17 and 18: FRIDAY, JANUARY 18, 2013, 3:00 PM S
- Page 19 and 20: CABARRUS COUNTY BOARD OF COMMISSION
- Page 21 and 22: Cabarrus County Budget Amendment Re
- Page 23 and 24: North Carolina Department of Transp
- Page 25 and 26: Based on the Revised Summary Sheet
- Page 27 and 28: CABARRUS COUNTY BOARD OF COMMISSION
- Page 29 and 30: Cabarrus County Budget Amendment Re
- Page 31 and 32: Section II. A. Special appropriatio
- Page 33 and 34: CABARRUS COUNTY BOARD OF COMMISSION
- Page 35 and 36: Specifications for a Type 1 (conven
- Page 37 and 38: When submitting their Bid Proposal,
- Page 39 and 40: Scope This specification covers a n
- Page 41 and 42: Does your bid comply? Yes __X__ No_
- Page 43 and 44: All bid prices and conditions must
- Page 45 and 46: The term "heavy-duty" as used to de
- Page 47 and 48: Front Suspension - front independen
- Page 49 and 50: Trailer tow hooks - front (2) Wheel
- Page 51: ventilated with clean air. The syst
- Page 55 and 56: Does your bid comply? Yes __X__ No_
- Page 57 and 58: Mud Flaps In order to provide addit
- Page 59 and 60: Driver's Compartment Controls The F
- Page 61 and 62: Does your bid comply? Yes __X__ No_
- Page 63 and 64: Circuit Connections Circuit connect
- Page 65 and 66: Does your bid comply? Yes __X__ No_
- Page 67 and 68: control console and will be an inte
- Page 69 and 70: Each compartment and module entry d
- Page 71 and 72: There shall be provided a clear LED
- Page 73 and 74: The vertical corner posts and the r
- Page 75 and 76: Does your bid comply? Yes __X__ No_
- Page 77 and 78: Side Window There shall be a fixed
- Page 79 and 80: (Q). Each compartment door shall ha
- Page 81 and 82: Dimensions given here are applicabl
- Page 83 and 84: Floor The sub floor of module body
- Page 85 and 86: Patient Compartment Carbon Monoxide
- Page 87 and 88: eak angles and locations to be pre-
- Page 89 and 90: Cabinet Layout See drawings accompa
- Page 91 and 92: controlled by a low voltage switch
- Page 93 and 94: Two (2) 100-watt Cast SA4319 speake
- Page 95 and 96: of F3963 and F3964 etch primer. The
- Page 97 and 98: CABARRUS COUNTY BOARD OF COMMISSION
- Page 99 and 100: EXTRACT FROM MINUTES OF PUBLIC HEAR
- Page 101 and 102: EXTRACT FROM MINUTES OF MEETING BOA
Engine High-Idle Speed Control, Automatic<br />
The vehicle shall be equipped with a high idle system. The device shall operate only when the transmission is<br />
in "Neutral" or "Park", and the parking brake has been engaged. The device shall disengage when the<br />
operator depresses the service brake pedal, the transmission is placed in gear, or parking brake is disengaged<br />
and automatically re-engages when the service brake is released, when the transmission is placed in neutral or<br />
park, and the parking brake is re-engaged.<br />
Does your bid comply?<br />
Yes __X__ No_____<br />
Exhaust System<br />
The exhaust system shall be the OEM manufacturer's standard. There shall be galvanized heat shields above<br />
the exhaust system in accordance with Ford’s QVM. The heat shields must be a minimum of 16-gauge material<br />
for additional strength and to prevent rattling.<br />
Does your bid comply?<br />
Yes __X__ No_____<br />
Fuel Tank/Diesel Exhaust Fluid Tank<br />
The vehicle shall be equipped with a single fuel tank, having a capacity of at least 57 gallons for the Type III and<br />
40 gallons for the Type I. There shall be a cast aluminum fill mounted and sealed to the ambulance body, with<br />
a brushed stainless steel paint protection plate extending from the fill downward to the bottom of the body or<br />
top of the rub rail. This plate shall be securely adhered and sealed to the surface of the body, not fastened<br />
with rivets or screws.<br />
The Diesel Exhaust Fluid tank shall not be modified from OEM standards in any way, including the location of<br />
the fill or hoses. There shall be a cast aluminum fill mounted and sealed to the ambulance body, with a<br />
brushed stainless steel paint protection plate extending from the fill downward to the bottom of the body or<br />
top of the rub rail. This plate shall be securely adhered and sealed to the surface of the body, not fastened<br />
with rivets or screws.<br />
Does your bid comply?<br />
Yes __X__ No_____<br />
19<br />
Attachment number 1<br />
4-4<br />
Page 53