E.g. Wheels, Bearings, Hubs, Drive Shafts, Etc.

More documents

Recommendations

Info

Wheel Hubs KL-0174 Puller Series Puller Bolts Puller plates Nut The KL-0174 Puller Series used together with the hydraulic cylinder KL-0215-10 (17t.) or with the hydraulic spindle KL-0045-7 (12t.) allow to press out drive shafts glued with loctite or rusted. Together with the slide hammer KL-0049-31 wheel hubs, brake drums and half shafts can be removed directly in-situ on the vehicle. Thanks to the use and combination of different perforated disks, tie bolts and drives the Puller Series KL-0174 is almost universally applicable. Adaptor Spindle Application: Slide Hammer Drive shaft pressing out: mechanical or hydraulic drive e.g. the use of the 17 t. hydraulic cylinder KL-0040-2500 and of the press spindle KL-0039-1930) allows you to press out even rusted, very stuck or glued drive shafts. Wheel Hubs Wheel hubs, half shafts and brake drums removal: with slide hammer KL-0049-31 By using the slide hammer KL-0049-31 wheel hubs, brake drums and half shafts can be removed directly in-situ on the vehicle. Standard Hub, 4 Wheel Bolts Standard Hub, 5 Wheel nuts 4X4 Off-Road, 6 Wheel nuts In order to select the correct puller, the following important data must be known: PCD and number of studs (3, 4, 5 or 6). important to determine the correct plate size with the correct hole pattern Position of wheel bolts number of pitches (here 4) Thread diameter of wheel bolts or nuts Pitch Circle Diameter (PCD) Wheel Hub Wheel nuts (type M) or Screws (type B) and thread diameters. important to determine the puller bolts with inner or outer threads. What drive method is to be used, mechanical spindle, slide-hammer, Hydraulic spindle or Hydraulic Cylinder? important to determine the appropriate adaptor. (see table) 3.3-1 (98) Copyright KLANN-Spezial-Werkzeugbau-GmbH, Germany - 6.E1
Axle repairs e.g. Wheels, Bearings, Hubs, Drive Shafts, etc. Wheel Hubs KL-0174 Puller Series Components for the assembly of a Puller from the Puller-Series KL-0174-... The puller plates with the sizes 0, 1, 2 and 3 can be assembled to an all-purpose puller-system by using different adaptors, spindles, puller bolts, screws and drives. 1. Assembling and mounting the puller: 2. Pressing out the drive shaft: 3. Extracting the wheel hub: Examples of application: Removing the hub using a slide-hammer Pressing out the drive-shaft ange Pressing out the drive-shaft using 17 ton Hydraulic Cylinder. Pressing out the drive-shaft with the mechanical spindle. KL-0174-559 KL-0174-559 KL-0040-2500 Copyright KLANN-Spezial-Werkzeugbau-GmbH, Germany - 6.E1 (99) 3.3-2
Page 1 and 2: Axle repairs e.g. Wheels, Bearings,
Page 25: Axle repairs e.g. Wheels, Bearings,

E.g. Wheels, Bearings, Hubs, Drive Shafts, Etc.

Create successful ePaper yourself

Delete template?

Save as template?