Manual - Sharkoon
Manual - Sharkoon Manual - Sharkoon
7. Mounting an optical drive 1. Reach into the case and press the 5.25" front bezel of the mounting bay in which you want to install the drive out of the case's front panel (fig. 11). Remove the quick fasteners from both sides of the mounting bay (fig. 12). fig. 11 fig. 12 (In case there is a metal bezel covering the mounting bay, remove it by using a gripper.) 3. Slide the optical drive into the mounting bay from the front until the drive is flush with the front panel (fig. 13). fig. 13 VAYA VALUE 10
4. Attach the HDD from both sides using the respective quick fasteners (fig. 14). fig. 14 Note: If you want to transport the case we recommend securing (additionally) the installed drives using the respective mounting screws (fig. 15). (Screws for drive mounting) fig. 15 5. Connect the optical drive to the PSU and the mainboard. (Replace the side panels to the case.) VAYA VALUE 11
- Page 1 and 2: Manual www.sharkoon.com
- Page 3 and 4: 1. Features • ATX case • 4x 5.2
- Page 5 and 6: 3. The case at a glance Front view
- Page 7 and 8: View from below A A A - Case feet B
- Page 9 and 10: 3. Remove the mainboard and screw t
- Page 11: 6. Mounting a hard disk drive 1. Ta
- Page 15: 9. Mounting an add-on card (Take th
7. Mounting an optical drive<br />
1. Reach into the case and press the 5.25" front bezel of the mounting bay in which you want to install the<br />
drive out of the case's front panel (fig. 11). Remove the quick fasteners from both sides of the mounting<br />
bay (fig. 12).<br />
fig. 11<br />
fig. 12<br />
(In case there is a metal bezel covering the mounting bay, remove it by using a gripper.)<br />
3. Slide the optical drive into the mounting bay from the front until the drive is flush with the front panel<br />
(fig. 13).<br />
fig. 13<br />
<br />
VAYA VALUE<br />
10