Manual - Sharkoon

More documents

Recommendations

Info

5. Mounting a power supply 1. Set up the case in front of you and put the PSU against the PSU bracket on the case’s rear side from the inside (fig. 5). fig. 5 2. Attach the PSU to the case from the outside using the included screws for PSU mounting (fig. 6). fig. 6 (Screws for PSU mounting) VAYA VALUE 8
6. Mounting a hard disk drive 1. Take the right side panel off the case. 2. Remove the quick fasteners from both sides of the HDD mounting bay in which you want to install the hard disk drive (fig. 7). fig. 7 3. Slide the HDD (its connector facing backwards, its label facing to the top) into the case's HDD mounting bay from the inside (fig. 8). fig. 8 4. Attach the HDD from both sides using the respective quick fasteners (fig. 9). fig. 9 Note: If you want to transport the case we recommend securing (additionally) the installed drives using the respective mounting screws: (Screws for HDD mounting) fig. 10 5. Connect the HDD to the PSU and the mainboard. VAYA VALUE 9
Page 1 and 2: Manual www.sharkoon.com
Page 3 and 4: 1. Features • ATX case • 4x 5.2
Page 5 and 6: 3. The case at a glance Front view
Page 7 and 8: View from below A A A - Case feet B
Page 9: 3. Remove the mainboard and screw t
Page 13 and 14: 4. Attach the HDD from both sides u
Page 15: 9. Mounting an add-on card (Take th

Manual - Sharkoon

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?