Ripple tank - Serrata Science Equipment

WAVES, VIBRATIONS AND SOUND
End piece with loudspeaker,
fitting for rubber tubing, fuse and jack connector
Resonance pipe 7 cm diameter x 100 cm
End piece with guide holes for the
measuring probe and tube fitting
mm scale Microphone Microphone probe 2515.50
2480.10 Resonance pipe (not including microphone probe and tripod supports)
ADDITIONAL EQUIPMENT NEEDED
2515.50 Microphone Probe
0006.00 Retort stand Base, Tripod
NB! The microphone probe is supplied with a DIN connector
which is compatible with data logger interface, in case use
of a computer is desired. If measurements are desired using
an ordinary analog/digital meter or oscilloscope, type
2515.60 power supply box. If measurements are desired
using an ordinary analog/digital meter or oscilloscope, type
2515.60 power supply box is required (also useful in other
experiments).
2515.50
Microphone Probe
A miniature microphone is mounted at the end of a 740
mm long 8 mm diameter stainless steel probe for measurement
of sound pressure levels in locations which are
hard to access. The frequency range is 20 to 20,000 Hz.
The probe is supplied with a 2 meter long cable with a DIN
connector for use with the 2515.60 power supply.
The microphone can be connected to a voltmeter or oscilloscope
via the 2515.60 power supply.
The probe is intended for use with 2480.10 resonance
pipe.
2515.50 Microphone Probe
2475.00
Kundt's Resonance Pipe
This apparatus is designed for demonstration of standing
waves and for determination of the wavelengths of
sound waves in air. The pipe is supplied with a millimeter
scale and a moveable piston for changing the length
of the air column. Dimensions: Length 66 cm, diameter
3 cm.
2475.00 Kundt's Resonance Pipe
ADDITIONAL EQUIPMENT NEEDED
Suitable tuning fork:
2240.10 Tuning Fork 1000 Hz
2245.61 Striking Hammer
2515.60
Power supply
The power supply is designed for use with microphones
and other sensors which need a + 5 VDC to
operate. The unit is provided with a battery compartment
for 9 V alkaline battery type 6LR61 (3510.10)
which via an electronic regulator supplies the +5 VDC
supply voltage for connected probes. The unit has two
input terminals with 6-pole DIN connectors (270
degrees) and one input terminal with a 6-pole DIN
connector (180 degrees).
The output terminals for attachment of measuring devices
are 3-pole DIN connectors and 4 mm jack connectors
(safety type). When making measurements with
the microphone probe 2515.10 if the connection is
made to the input connector marked Mic 2, then an
oscilloscope can be connected to the jack connectors.
Dimensions (LxBxH): 14.3 x 8.4 x 3.7 cm.
2515.60 Power supply
33