Circuit-breakers NZM1, 2, 3, 4 up to 2000 A - Moeller Electric Parts

More documents

Recommendations

Info

For Moeller Electric Sales and Support call KMparts.com (866) 595-9616 10/58 Ordering Connection types Ordering Connection types 10/59 Circuit-breakers. switch-disconnectors Cover Phase isolator NZM3 Max. cable connection area For use with For use with – – NZM3(-4), PN3(-4), N(S)3(-4) Moeller HPL0211-2007/2008 For use with Part no. Article no. when ordered separately 3 pole NZM3-XKSA 260045 – – 4 pole NZM3-4-XKSA 266801 – – NZM3(-4), PN3(-4), N(S)3(-4) 3 pole NZM3-XKP 100512 – – 4 pole NZM3-4-XKP 100513 http://catalog.moeller.net http://catalog.moeller.net Std. pack Notes Moeller HPL0211-2007/2008 1 off Type contains parts for a terminal located at top or bottom for 3 or 4-pole circuit-breakers. Insulation/protection against direct contact where cable lugs, busbars or tunnel terminals are used. 1 off Included in set with tunnel terminals Degree of protection IP1X on the connection side when using insulated conductor material. 1 off Type contains parts for a terminal located at top or bottom for3 or 4 pole circuit-breakers. Included with the connection width extension. 1 off Cannot be combined with the NZM3(-4)-XKA tunnel terminal, NZM3(-4)-XKR connection on rear. Insulation protection with connection of cable lugs, busbars or braid. NZM3 Circuit-breakers. switch-disconnectors Connection cover, knockout – – NZM3(-4), PN3(-4), N(S)3(-4) IP2X protection against contact with a finger 3 pole NZM3-XKSFA 104642 – – 4 pole NZM3-4-XKSFA 104643 – NZM3(-4), PN3(-4), N3(-4) 3 pole NZM3-XIPK 266804 4 pole NZM3-4-XIPK 266805 1 off Type contains parts for a terminal located at top or bottom for 3 or 4-pole circuit-breakers. Enhancement of the protection against direct contact to (simplified protection against contact with a finger). 1 off 1 off Type contains parts for a terminal located at top or bottom for 3 or 4-pole circuit-breakers. Enhancement of the protection against direct contact to IP2X. 1 off Protection when reaching into the cable connection area with the connection of cables in the box terminal. With 2 conductors minimum cross-section 70 mm 2 00 or AW00. Cannot be combined with NZM-XSTK control circuit terminal. For cover NZM3(-4)-XKSA or NZM3...(C)NA and N(S)3...NA – NZM3(-4), PN3(-4), N(S)3(-4) 3 pole NZM3-XIPA 266808 – 4 pole NZM3-4-XIPA 266809 Copper cable lug not UL/CSA approved When using cable lugs without NZM3(-4)-XKSA cover, they must be insulated. 185 mm 2 – NZM3(-4), PN3, N(S)3(-4) NZM4(-4), N(S)4(-4) 3 and 4 pole NZM3-XKS185 260040 900 mm 2 – 3 and 4 pole NZM3-XKS240 260041 1 off Type contains parts for a terminal located at top or bottom for 3 or 4-pole circuit-breakers. Enhancement of the protection against direct contact to IP2X. When mounting NZM3-..-(C)NA or N3...-NA the following applies: 1 off With 2 conductors minimum cross-section 70 mm 2 00 or AW00. 3 off Type contains a cable lug for 3-pole or 4-pole switches. Special cable lug, narrow style 3 off
For Moeller Electric Sales and Support call KMparts.com (866) 595-9616 Circuit-breakers. switch-disconnectors 10/60 Ordering Connection types NZM4 Max. cable connection area Rated current Screw connection Standard equipment 2-hole max. 1250 NZM4(-4) N4(-4) N(S)4 o10.5 25 50 o10.5 20 Moeller HPL0211-2007/2008 http://catalog.moeller.net http://catalog.moeller.net Moeller HPL0211-2007/2008 For use with Terminal capacities Terminal capacities Part no. Article no. when ordered separately Type of conductor Terminal capacities AWG/kcmil Cu strip (number of segments x width x segment thickness) I n A mm 2 mm mm Three- and four-pole Cu cable lugs 1 x 120 – 185 4 x 50 – 185 1 x 250 – 350 4 x 0 – 350 Copper busbar width x thickness Std. pack Notes Ordering Connection types (2 x) 10 x 50 x 1.0 (2 x) 50 x 10 off Double hole fitting for M10 screws with 25 mm clearance. Use special cable lug narrow version. U e f 525 V or cross-section > 185 mm 2 : Use of shroud NZM4(-4)- XKSA required. 1600 off 3-hole 2000 NZM4 3 pole Cu cable lugs (2 x) 80 x 10 off Triple hole fitting for M10 screws with 25 mm pitch. Phase divider for insultion above is supplied. 20 NZM4 10/61 Circuit-breakers. switch-disconnectors o10.5 25 o10.5 80 25 o10.5 Module plate Single hole Double hole Double hole Connection width extension max. 1250 NZM4, N(S)4 3 pole Copper cable lugs 1 x 120 – 300 2 x 95 – 300 1 x 250 – 600 2 x 000 – 600 (2 x) 10 x 40 x 1.0 (2 x) 10 x 50 x 1.0 (2 x) 40 x 10 (2 x) 50 x 10 NZM4-XKM1 266814 NZM4-4, N4-4 4 pole NZM4-4-XKM1 266815 max. 1400 NZM4, N(S)4 3 pole Copper cable lugs 2 x 95 – 185 4 x 35 – 185 4 x 50 2 x 000 – 350 4 x 2 – 350 NZM4-XKM2 266820 NZM4-4, N4-4 4 pole NZM4-4-XKM2 266821 max. 1250 NZM4, N(S)4 3 pole Copper cable lugs 2 x 95 – 300 2 x 000 – 600 NZM4-XKM2S- 1250 284471 NZM4-4, N4-4 4 pole NZM4-4-XKM2S- 1250 284472 max. 1600 NZM4, N(S)4 3 pole Copper cable lugs 2 x 95 – 300 2 x 000 – 500 NZM4-XKM2S- 1600 284473 NZM4-4, N4-4 4 pole 2 x 95 – 300 2 x 000 – 500 NZM4-4-XKM2S- 1600 284474 max. 1600 NZM4, N(S)4 3 pole Cu cable lugs 4 x 300 6 x 95 – 240 4 x 600 6 x 000 … 500 min.10 x 50 x 1.0 max. (2 x) 80 x 10 NZM4-XKV95 281591 NZM4-XKV110 281593 NZM4-4, N4-4 4 pole NZM4-4-XKV95 281592 NZM4-4-XKV120 281594 1 off Type contains parts for a terminal located at top or bottom for 3 or 4-pole circuit-breakers. 1 off For M10 screws. Can be enlarged for M12 screws. Use special cable lug narrow version. Can be fitted to circuit-breaker with screw termination 1 off Insulation through NZM4(-4)-XKSA cover or NZM4(-4)-XKP phase separator necessary 1 off 1 off Type contains parts for a terminal located at top or bottom for 3 or 4-pole circuit-breakers. Insulation through cover NZM4(-4)-XKSA or phase isolator 1 off NZM4(4)-XKP necessary. 1 off 1 off 1 off Type contains parts for a terminal located at top or bottom for 3 or 4-pole circuit-breakers. 1 off Five way holes, e.g. for up to 9 cable lugs per phase. Can be fitted to circuit-breaker with screw termination Phase isolator supplied. 1 off Distance between pole centres with NZM4(-4)-XKV95: 95 mm Installation conditions for current transformer up to 130 mm width 1 off with 80 mm busbar width. Distance between pole centres with NZM4-XKV110: 107.5 mm Installation conditions for current transformer up to 135 mm width with 80 mm busbar width. Distance between pole centres with NZM4-4-XKV120: 122 mm Installation conditions for current transformer up to 164 mm width with 80 mm busbar width. 4 mm drilled holes for control circuit terminal available. Notes 1) The following applies for the rated current: The values have been determined conform to IEC/EN 60947 (switchgear standard) and generally relate to the max. defined cross-sections and are intended for the purpose of orientation.
Page 1 and 2: Contents 10/1 Moeller HPL0211-2007/
Page 3 and 4: System overview Circuit-breakers, s
Page 5 and 6: For Moeller Electric Sales and Supp
Page 15 and 16: Ordering Switch-disconnectors, 4-po
Page 33: For Moeller Electric Sales and Supp
Page 39 and 40: 10/68 Ordering Plug-in units Moelle
Page 47 and 48: Ordering Undervoltage releases, off
Page 49 and 50: Ordering Shunt releases with screw
Page 51 and 52: Ordering Shunt releases with screw
Page 55 and 56: Ordering Rotary handles with door i
Page 59 and 60: Ordering Accessories 10/91 http://c
Page 61 and 62: Ordering Mechanical interlock 10/93
Page 63 and 64: Ordering Multi-function device adap
Page 73 and 74: Engineering Direction of blow-out,
Page 85 and 86:
Engineering Frame size 2: residual-
Page 87 and 88:
For Moeller Electric Sales and Supp
Page 89 and 90:
Technical data Circuit-breaker, swi
Page 91 and 92:
Technical data Moulded Case Switch
Page 93 and 94:
Technical data Temperature influenc
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Technical data Field Bus connection
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
R46 For Moeller Electric Sales and
Page 109 and 110:
10/150 Dimensions Size 1: accessori
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
10/184 Dimensions Frame size 4: N12
Page 145 and 146:
Page 147 and 148:
show all

Circuit-breakers NZM1, 2, 3, 4 up to 2000 A - Moeller Electric Parts

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?