Kenwood TH-D7A
Kenwood TH-D7A
Kenwood TH-D7A
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
PREPARATION FLOW<br />
The following steps should guide you to a good start of<br />
Sky Command operation. First connect the Transporter<br />
to the HF transceiver {page 84}.<br />
q On the Commander<br />
and Transporter<br />
w On the Commander<br />
e On the Commander<br />
r On the Transporter<br />
t On the Transporter<br />
Select the same VHF and UHF<br />
frequencies.<br />
Access Menu 4–1 to program<br />
a call sign (9 digits max.) for<br />
the Commander {page 86}.<br />
• You may enter your exact call<br />
sign; ex. WD6BQD.<br />
Access Menu 4–2 to program<br />
a call sign (9 digits max.) for<br />
the Transporter {page 86}.<br />
• This call sign must be different<br />
from the one for the<br />
Commander. So you may add<br />
SSID characters; ex.<br />
WD6BQD-1.<br />
Access Menu 4–1 to program<br />
the same call sign as you<br />
entered in step w {page 86}.<br />
Access Menu 4–2 to program<br />
the same call sign as you<br />
entered in step e {page 86}.<br />
y On the Commander<br />
and Transporter<br />
u On the Commander<br />
i On the Transporter<br />
Access Menu 4–3 and select<br />
the tone frequency {page 86}.<br />
• Select the same tone frequency<br />
on both transceivers.<br />
• For the selectable frequencies,<br />
see the table given on page 22.<br />
Access Menu 4–4 and select<br />
“COMMANDER”.<br />
• “PUSH [ 0 ] KEY TO START<br />
COMMANDER!!” appears.<br />
Access Menu 4–4 and select<br />
“TRANSPORTER”.<br />
• “TRANSPORTER” appears.<br />
Now the Commander and Transporter are in Sky<br />
Command mode. For operations in this mode, see<br />
“CONTROL OPERATION” on page 87. First switch ON<br />
the HF transceiver and press [SYNC] on the<br />
Commander. To exit the Sky Command mode, access<br />
Menu 4–4 and select “OFF”; press [F], [1] to switch the<br />
Tone function OFF, and press [DUP] to exit Full Duplex<br />
mode.<br />
Note:<br />
◆ Unless you program call signs, you cannot select “COMMANDER” or<br />
“TRANSPORTER” using Menu 4–4 .<br />
◆ On the HF transceiver, select 9600 bps and 1 stop bit (default) using<br />
the Menu Setup function.<br />
◆ Adjust the audio level on both the Transporter and HF transceiver.<br />
1<br />
2<br />
3<br />
4<br />
5<br />
6<br />
7<br />
8<br />
9<br />
10<br />
11<br />
12<br />
13<br />
14<br />
15<br />
16<br />
17<br />
18<br />
19<br />
20<br />
21<br />
22<br />
23<br />
85