Kenwood TH-D7A

RECEIVING A MESSAGE
Each time a proper message is received, the frequency
display is interrupted to show information as below:
Indicator
5
• The display shows only the first 24 characters of the message.
• The transceiver restores the frequency display after
approximately 10 seconds pass or when you press any key.
• “ ” appears and stays at the bottom left of the display until
you use the List function {page 78}.
5
STA CON
7 9
STA CON
7 9
96 BCONDUP
96 BCONDUP
The following indicators appear depending on types of
received messages:
1
0~9
A personal message to you
1 1
0~9
, A~ Z A bulletin to all stations in your group
! A report by the National Weather Service
Reception
message
acknowledgment to your
1 Sequence of message (or bulletin) packets from the same
station
When a duplicate message from the same station is
received, an error beep sounds. In addition, “dM” and a
call sign appear on the display.
• When a message to other stations is received, “oM”
appears at the bottom left of the display.
This transceiver beeps each time it receives a new or
duplicate message. You may access Menu 1–5–3
(BEEP) to change this setting. The default is “ALL”.
Selections
OFF
KEY
KEY+NEW DATA
ALL
5
STA CON
7 9
Key Pressed
No
beep
Beep
Beep
Beep
96 BCONDUP
New
Message
No
beep
No
beep
Beep
Beep
Duplicate
Message
No beep
No beep
No beep
Beep
Note:
◆ This transceiver allows you to receive a message also when the
SSID does not match. However, it will not return a reception
acknowledgment.
◆ When a message addressed to you is received, the transceiver
display and keypad are illuminated. If you do not press any key in
approximately 5 seconds, the light goes off.
77
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23