Kenwood TH-D7A
Kenwood TH-D7A
Kenwood TH-D7A
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
DX PACKETCLUSTERS MONITOR<br />
1<br />
2<br />
3<br />
4<br />
5<br />
6<br />
7<br />
8<br />
9<br />
10<br />
11<br />
12<br />
13<br />
14<br />
15<br />
16<br />
17<br />
18<br />
19<br />
20<br />
21<br />
22<br />
23<br />
DX PacketClusters are networks which consist of nodes<br />
and stations who are interested in DXing and contesting.<br />
If one station finds a DX station on the air, he (or she)<br />
sends a notice to his (or her) node. Then this node<br />
passes the information to all its local stations besides<br />
another node. This transceiver can display received DX<br />
information and hold the latest information on up to 10<br />
DX stations. Use this function to monitor the latest DX<br />
information in your local area. You cannot send DX<br />
information to a node, using the function.<br />
1 Access Menu 1–4–1 (DATA BAND) to select band A or B.<br />
2 Tune to the frequency of the target PacketCluster node.<br />
3 Press [TNC] to switch ON the TNC.<br />
56<br />
Node<br />
• “ ” appears.<br />
Station<br />
Node<br />
5<br />
STA CON<br />
7 9<br />
96 BCONDUP<br />
Node<br />
Each time new DX cluster data is received, the frequency<br />
display is interrupted to show information as below:<br />
5<br />
STA CON<br />
7 9<br />
96 BCONDUP<br />
• The transceiver restores the frequency display after<br />
approximately 10 seconds pass or when you press any key.<br />
• When duplicate DX cluster data is received, the frequency<br />
display is not interrupted. “dD” and a call sign will appear at<br />
the bottom of the display.<br />
To scroll through up to 10 sets of DX information, press<br />
[LIST] twice, then press [UP]/ [DWN].<br />
• Press [OK] to access an attached comment (20 characters<br />
max.).<br />
5<br />
STA CON<br />
7 9<br />
96 BCONDUP<br />
• Press [LIST] to restore the frequency display.<br />
Frequency<br />
Time<br />
Comment<br />
Note:<br />
◆ The information is cleared when the transceiver power is turned OFF.<br />
◆ This transceiver beeps each time it receives new or duplicate DX<br />
cluster data. You may access Menu 1–5–3 (BEEP) to change this<br />
setting. The default is “ALL”. See the table on page 63.<br />
◆ Before tuning to a PacketCluster node, switch the APRS Beacon<br />
function OFF {page 74}; otherwise, unintentional APRS packet<br />
transmission will annoy PacketCluster nodes and stations.