Kenwood TH-D7A

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
POWER-ON MESSAGE
Each time you switch the transceiver ON, “HELLO !!”
appears and stays for approximately 1 second. You can
program your favorite message in place of the factory
default.
1 Press [MENU] to enter Menu mode.
2 Press [1], [1], [1] to select “1–1–1 (PWR ON MSG)”.
• The display for entering a message appears; the first
digit blinks.
3 Press [UP]/ [DWN] to select a character.
• You can enter alphanumeric characters plus special
ASCII characters.
4 Press [OK].
• The cursor moves to the next digit.
5 Repeat steps 3 and 4 to enter up to 8 digits.
• Pressing [OK] after selecting the 8th digit completes the
programming.
• To complete programming the message after entering
less than 8 digits, press [OK] twice.
• Each press of [ESC] causes the cursor to move
backward.
• Pressing [A/B] deletes the digit at which the cursor is
blinking.
50
6 Press [MENU] to exit Menu mode.
You can also use the keypad to enter alphanumeric
characters in step 3. For example, each press of [TNC]
switches entry as A, B, C, a, b, c, then 2. Press [DUAL]
to switch 0 and space. Press [ENT] to switch among the
special ASCII characters.
TRANSCEIVER LOCK
This function prevents accidental changes, or
unauthorized individuals from changing the transceiver
settings.
Press [F] (1 s) to switch the function ON (or OFF).
• A key icon appears when the function is ON.
5
STA CON PACKET96 BCONDUP
7 9
You may want to use the Tuning control or [UP]/ [DWN]
in Transceiver Lock mode. Access Menu 1–5–4 (TUNE
ENABLE) and select “ON”.