Kenwood TH-D7A
Kenwood TH-D7A
Kenwood TH-D7A
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
1<br />
2<br />
3<br />
4<br />
5<br />
6<br />
7<br />
8<br />
9<br />
10<br />
11<br />
12<br />
13<br />
14<br />
15<br />
16<br />
17<br />
18<br />
19<br />
20<br />
21<br />
22<br />
23<br />
SELECTING SCAN RESUME ME<strong>TH</strong>OD<br />
The transceiver stops scanning at a frequency (or<br />
memory channel) on which a signal is detected. It then<br />
continues scanning according to which resume mode<br />
you select. You can choose one of the following modes.<br />
The default is Time-operated mode.<br />
• Time-Operated mode<br />
The transceiver remains on a busy frequency (or<br />
memory channel) for approximately 5 seconds, and<br />
then continues to scan even if the signal is still<br />
present.<br />
• Carrier-Operated mode<br />
The transceiver remains on a busy frequency (or<br />
memory channel) until the signal drops out. There is<br />
a 2 second delay between signal drop-out and scan<br />
resumption.<br />
• Seek mode<br />
The transceiver remains on a busy frequency (or<br />
memory channel) even after the signal drops out and<br />
does not automatically resume scanning.<br />
Note: To temporarily stop scanning and monitor weak signals, press and<br />
hold [MONI]. Release the key to resume scanning.<br />
1 Press [MENU] to enter Menu mode.<br />
2 Press [1], [5], [2] to select “1–5–2 (SCAN<br />
RESUME)”.<br />
3 Press [UP]/ [DWN] to select Time-Operated (default),<br />
Carrier-Operated, or Seek.<br />
4 Press [OK] to complete the setting.<br />
5 Press [MENU] to exit Menu mode.<br />
34