Kenwood TH-D7A
Kenwood TH-D7A
Kenwood TH-D7A
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
1<br />
2<br />
3<br />
4<br />
5<br />
6<br />
7<br />
8<br />
9<br />
10<br />
11<br />
12<br />
13<br />
14<br />
15<br />
16<br />
17<br />
18<br />
19<br />
20<br />
21<br />
22<br />
23<br />
REVERSE FUNCTION<br />
The reverse function exchanges a separate receive and<br />
transmit frequency. So, while using a repeater, you can<br />
manually check the strength of a signal that you receive<br />
directly from the other station. If the station’s signal is<br />
strong, both stations should move to a simplex frequency<br />
and free up the repeater.<br />
TX: 144.725 MHz TX: 144.725 MHz TX: 144.725 MHz TX: 145.325 MHz<br />
RX: 145.325 MHz RX: 145.325 MHz RX: 145.325 MHz RX: 144.725 MHz<br />
Press [REV] to switch the Reverse function ON (or<br />
OFF).<br />
• “R” appears when the function is ON.<br />
Note:<br />
◆ If pressing [REV] places the transmit frequency outside the allowable<br />
range, then pressing the PTT switch causes an error beep to sound;<br />
transmission is inhibited.<br />
◆ If pressing [REV] places the receive frequency outside the allowable<br />
range, an error beep sounds and no reversal occurs.<br />
◆ Automatic Repeater Offset does not function while Reverse is ON.<br />
◆ You cannot switch Reverse ON or OFF while transmitting.<br />
24<br />
144.725 MHz<br />
145.325 MHz<br />
5<br />
144.725 MHz<br />
STA CON PACKET96 BCONDUP<br />
7 9<br />
REV ON<br />
AUTOMATIC SIMPLEX CHECK (ASC)<br />
While using a repeater, ASC periodically monitors the<br />
strength of a signal that you receive directly from the<br />
other station. If the station’s signal is strong enough to<br />
allow direct contact without a repeater, the ASC indicator<br />
on the display begins blinking.<br />
Press [REV] (1 s) to switch the function ON.<br />
• “ ” appears when the function is ON.<br />
STA CON PACKET96 BCONDUP<br />
7 9<br />
• While direct contact is possible, the ASC indicator blinks.<br />
• To quit the function, press [REV] momentarily.<br />
Note:<br />
◆ Pressing the PTT switch causes the ASC indicator to quit blinking.<br />
◆ ASC does not function if your transmit and receive frequencies are<br />
the same (simplex operation).<br />
◆ ASC does not function while scanning.<br />
◆ Activating ASC while using Reverse switches Reverse OFF.<br />
◆ If you recall a memory channel or the Call channel that contains<br />
Reverse ON status, ASC is switched OFF.<br />
◆ ASC causes receive audio to be momentarily intermitted every 3<br />
seconds.<br />
5