Pulmonary Medicine Service Design Guide - Office of Construction ...

PULMONARY MEDICINE SERVICE NOVEMBER 29, 2011
Testing Lab, Extended Pulmonary Function (OPPF2)
Room Data Sheet
ARCHITECTURAL
HEATING, VENTILATING AND AIR CONDITIONING
Ceiling: AT Dry Bulb Temp Cooling: 75˚F (24˚C)
Ceiling Height: 9’-0” Dry Bulb Temp Heating: 70˚F (21˚C)
Wall Finish: GWB Minimum % Outside Air: 2
Base: RB 100% Exhaust Air:
Floor Finish: SVT Noise Criteria: NC 35
Door: 1/2 X-T Steam:
Hardware: 4G Relative Humidity/Cooling: 60%
Relative Humidity/Heating: 20%
Minimum Air Changes/Hr.: 8
Notes: Room Pressure: Neutral (0)
AC Load Lights:
As Required
AC Load Equipment:
As Required
POWER Number of People: 3
General: As Shown Special Equipment:
Special:
Special Voltage as Required
Emergency:
PLUMBING AND MEDICAL GASES
Notes: Dedicated Power Required Cold Water: Yes
Hot Water:
Yes
Domestic Water (HWH):
Yes
COMMUNICATIONS
Laboratory Air:
Patient Monitor: Laboratory Vacuum:
Nurse Call: Yes Sanitary/Vent: Yes
Security/Duress:
Medical Air:
CCTV:
Medical Vacuum:
Telephone: Yes Oxygen:
Pub. Address:
Nitrogen Oxide:
Radio:
Nitrogen:
Data: Yes Anesthesia Evac:
Panic Call: Sprinkler: Yes
Battery Operated Clock: Yes Tempered Water:
Intercom: Water Control: Infrared
Staff/Duty Station:
LIGHTING
General:
1. Two (2) of 2’x4’ (600mm x 1200mm) Fluorescent
Light Fixture, Acrylic, Prismatic Lens with F32T8
Lamps, 3500˚K, CRI=70 (minimum)
2. Provide Ballasts Per Fixture for Desired Switching
Configuration
3. Lighting Level: 50fc
4. Under Cabinet Light
5. Ceiling Mounted Occupancy Sensors
SPECIAL EQUIPMENT
None
DESIGN STANDARDS
SECTION 4 - PAGE 55