Batteriestecker - Atech Antriebstechnik

| Powerpole ® PP180 Accessories |
Mounting Clamp
Mounting clamps can be used for fastening a block of
Powerpole ® 180 series housings to a panel. Connector
blocks must be a complete square for the clamps to work
properly. Fastening hardware not included.
Description - Part Numbers -
Minimum Quantity ... 20 sets of 2 .....
2 Pole 1465G1
3 Pole 1465G2
Mounting Clamp
Panel
2 Pole 3 Pole
SECTION 2
Powerpole ® PP180
Retaining Pins
Retaining pins are used to keep stacked Powerpole ® 180 series housings from separating.
Retaining pins are inserted in the circular opening between two housings stacked side by side.
Dimension “B” is +/- .015 in or .38 mm.
Dimensions
- A - - B -
Description ----- Part Numbers ----- inches mm
Minimum Quantity ... 1,000 100 ..................................................................................
1 Block High 111812P6 110G18 0.196 / 0.207 4.98 / 5.26 1.000 25.400
2 Block High 111812P8 110G20 0.196 / 0.207 4.98 / 5.26 1.500 38.100
B
A
Reducing Bushings
Use with contact part number 1382-BK to allow a smaller wire to be used with the connector. Electrical
capability is derated with smaller wire.
Dimensions
- ID -
Contact Barrel Size Wire Size ----------------- Part Numbers ---------------- inches mm
Minimum Quantity ..................................................... 1,500 1,000 500 100 ............................
1/0 AWG [53.5 mm²] #1 AWG [42.4 mm²] - - 5687-BK 5687 0.39 9.91
1/0 AWG [53.5 mm²] #2 AWG [33.6 mm²] 5690-BK - - 5690 0.34 8.64
1/0 AWG [53.5 mm²] #4 AWG [21.2 mm²] - 5693-BK - 5693 0.27 6.86
1/0 AWG [53.5 mm²] #6 AWG [13.3 mm²] - 5663-BK - 5663 0.22 5.59
1/0 AWG [53.5 mm²] #10 - 8 AWG [5.3 - 8.4 mm²] 5648-BK - - 5648 0.19 4.83
[ 25.4 ]
1.0
ID
Wire Entrance
For environmentally sealed connector shells to hold Powerpole ®
15-180 connectors, see APP ® ’s SPEC Pak ® product series on our
website, www.andersonpower.com
- 42 - www.andersonpower.com
All Data Subject To Change Without Notice