City of Oxnard - Bicycle and Pedestrian Master Plan Appendices

More documents

Recommendations

Info

City of Oxnard | Bicycle and Pedestrian Master Plan Recommended Design (continued) Design Example Short-term bicycle parking showing recommended clearances (non-local) Alta Planning + Design | A-41
Appendix A | Design Guidelines Additional Discussion – Rack Installation Racks will be affixed to City sidewalks or other concrete pad location by the utilization of vandal-resistant hardware provided by the installer and approved by the city. Racks will be installed in locations as designated by the city. In most cases racks will be sited for installation in clusters for a significant length of busy business districts. Racks will be installed or removed in/from locations as designated by the city. All bicycle racks shall be installed at locations approved by city staff. All installations shall conform to Americans with Disabilities Act (ADA) requirements. All bolt holes shall be clean of dust or any debris. The anchoring bolts should be driven vertically through the support plate into the bolt holes until the bolt head is firmly seated against the support plate. For pavement surfaces that are not level use washers to level the rack and support plate. Fill with non-shrinking grout after the bicycle rack is mounted to the concrete. Do not place bicycle rack over any pavement expansion or control joint. Bicycle rack shall be placed at least 3 inches away from any expansion and or control joints in the cement. Requirements for Multiple Bicycle Parking Installation • Bicycle racks can be placed perpendicular or parallel to a building. • Bicycle racks should be placed at least 24 to 30 inches from a wall or structure. • When racks are placed side by side each rack should be spaced at least 30 to 48 inches from one another. Measured from the center of the rack. • There should be sufficient room for a rider and a bicycle to fit in the aisle, and the total width between bicycle racks should be at least 5 feet wide. A-42 | Alta Planning + Design
Page 1 and 2: City of Oxnard Bicycle & Pedestrian
Page 3 and 4: Appendix A | Design Guidelines Tabl
Page 5 and 6: Appendix A | Design Guidelines Figu
Page 7 and 8: Appendix A | Design Guidelines •
Page 9 and 10: Appendix A | Design Guidelines Desi
Page 11 and 12: Appendix A | Design Guidelines A.2.
Page 15 and 16: Appendix A | Design Guidelines http
Page 17 and 18: Appendix A | Design Guidelines Addi
Page 27 and 28: Appendix A | Design Guidelines A.4
Page 39 and 40: Appendix A | Design Guidelines •
Page 41: Appendix A | Design Guidelines A.6.
Page 45 and 46: Appendix A | Design Guidelines Cove
Page 79 and 80: Appendix A | Design Guidelines This
Page 81 and 82: Appendix B | Trip and Emissions Red
Page 89 and 90: Appendix C | Safety Review Table of
Page 91 and 92: Appendix C | Safety Review Route Be
Page 93 and 94:
Appendix C | Safety Review Existing
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Appendix C | Safety Review Route Be
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Appendix C | Safety Review This pag
Page 131:
Appendix D | Bicycle Transportation
show all

City of Oxnard - Bicycle and Pedestrian Master Plan Appendices

Create successful ePaper yourself

Delete template?

Save as template?