Hand-Held Applicators - Henkel Content Management System
Hand-Held Applicators - Henkel Content Management System
Hand-Held Applicators - Henkel Content Management System
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Diaphragm Valve 97135/97136<br />
In combination with a semi-automatic or automatic controller, Diaphragm Valves are suitable for dispensing all low<br />
(97135) to medium (97136) viscosity anaerobic and UV light curable adhesives. All wetted components inside the valve<br />
are PTFE to prevent premature curing. The valve has a simple design that facilitates cleaning, servicing and diaphragm<br />
replacement.<br />
The opening of the diaphragm takes place by pressurising an internal single-acting cylinder. When in idle position, the<br />
valve is held closed by spring pressure. Sealing in idle position is achieved by an internal spring pushing a piston<br />
against the diaphragm, re-seating the diaphragm over the flow path. The diaphragm valve is not suitable for moisture<br />
sensitive products like CAs.<br />
Recommended products: Acrylics, anaerobic adhesives and light curable adhesives<br />
Technical Specifications:<br />
Air Input<br />
min. 5-max. 7 bar (73-100 psi),<br />
filtered to a maximum of 10µm<br />
Dimensions (W x H x D)<br />
Product Outlet Luer-Lock output fitting Weight 300g<br />
Max. Product Pressure 4 bar (60 psi)<br />
ø 32 x 127mm<br />
Features:<br />
• Modular design of valve body<br />
and valve actuator provides<br />
on-line serviceability<br />
• Simple design, cost effective<br />
• Easy to service<br />
Shut-Off Valve 97664/97676<br />
The Shut-Off Valve is used in combination with the Eccentric Rotor Pump 3RD8-L / 4RD6-L / 3RD12-L for dispensing<br />
Loctite silicones (97664) or anaerobic sealants (97676). It is opened and closed by a double acting cylinder and<br />
provides a clean cut-off of the fluid flow from the dispensing nozzle.<br />
The valve is installed between eccentric rotor pump and dispensing needle. A pressure sensor can be screwed<br />
directly into the valve body for monitoring the amount of product dispensed.<br />
Recommended products: High viscosity and pasty sealants<br />
Technical Specifications:<br />
Max. Product 40 bar (580 psi) Dimensions (W x H x D) 142 x 75 x 50mm<br />
Pressure<br />
Air Inlet Port min. 5 bar (73 psi),<br />
max. 10 bar (145 psi)<br />
Air Quality<br />
Filtered, oil-free,<br />
or filtered, oiled<br />
Weight 600g Dispensing Needle<br />
Connector<br />
G 1/8<br />
Features:<br />
• Easy clean-up of product channel<br />
• Non-drip opening and closing<br />
• Self closing with spring return<br />
22
Change language