Equipment Care Tips (PDF) - AAA Carolinas
Equipment Care Tips (PDF) - AAA Carolinas
Equipment Care Tips (PDF) - AAA Carolinas
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Patrol <strong>Equipment</strong> <strong>Care</strong> <strong>Tips</strong><br />
Rain Poncho <strong>Care</strong><br />
If you have a poncho, protect it! The following suggestions will help you get the maximum years<br />
of wear:<br />
1. Hang the poncho on a wooden hanger with shoulders centered on the hanger<br />
arms.<br />
2. Hang in a place that is cool and away from direct sunlight and heat.<br />
3. Make certain that the sleeves are straight. Turned-back cuffs hold water and<br />
may cause cracking or mildew.<br />
4. If dirty, wipe clean with a damp cloth only.<br />
Belt <strong>Care</strong><br />
Your belt should be taken off during off-duty hours, rolled up, and kept in a designated place.<br />
Yellow-green fluorescent belts should be cleaned regularly with a damp cloth. Your belt will be<br />
bright and smart-looking if you take care of it!<br />
If your patrol belt needs washing:<br />
1. Pour some liquid soap or powder onto a damp cloth and scrub.<br />
2. Rinse the belt thoroughly.<br />
3. Artificial heat such as dryers or ovens should not be used for<br />
rapid drying.<br />
4. Alcohol and abrasive cleaners should not be used.<br />
Badge <strong>Care</strong><br />
Your badge should only be worn on the patrol belt. It should be<br />
pinned on the shoulder strip of the belt at chest level. Badges<br />
should be removed only when the belt is being washed. Removing<br />
and replacing the badge several times each day causes the pin to<br />
break.<br />
Badges may be cleaned by washing with a mild soap and water. It<br />
is important to immediately dry the badge. Abrasive polishes should<br />
not be used to clean badges.
How to Fold Your <strong>AAA</strong> School Safety Patrol Belt<br />
1. Beginning with your patrol belt laying on a<br />
flat surface, match the waist portion of the<br />
belt together and then the shoulder portion of<br />
the belt together.<br />
2. Fold under the right side of the waist portion of the belt.<br />
3. Fold under the left side of the of the waist<br />
portion of the belt.<br />
4. Fold under the shoulder portion of the belt so it wraps<br />
around the belt waist until folded completely.<br />
5. Secure with a rubber band.