Catalyst 6500 Series Switches Installation Guide - Ipland

CISCO SYSTEMS, INC
Removing and Installing the DC-Input Power Supplies
Chapter 4
Removal and Replacement Procedures
Figure 4-41
DC-Input Front Panel for 6000-W DC-Input Power Supply
1
7
2
3
8
8
9 9
RUN
INSTALL
191286
5
1 2 3 4
INPUT OK
FAN
OK
OUTPUT
FAIL
6
4
1 Terminal block cover 6 Captive installation screw
2 DC power cable terminal block 7 Input Power Module (IPM)
3 Ground 8 IPM captive screws
4 Status LEDs 9 IPM latches
5 Power switch
Note
Step 3
Step 4
With the PWR-6000-DC power supply, you have the option of removing the Input Power Module (IPM)
without disconnecting the DC-input wires and the ground wires. You can then replace your power supply
and insert the fully-wired IPM. To use this option, do not perform steps 3 through 6 and go to step 7.
Remove the two A4 screws securing the terminal block cover, and remove the cover from the power
supply (Figure 4-42).
Cut any cable tie-wraps being careful not to cut or nick the DC-input wires.
4-60
Catalyst 6500 Series Switches Installation Guide
OL-5781-08