14.11.2014 Views

Catalyst 6500 Series Switches Installation Guide - Ipland

Catalyst 6500 Series Switches Installation Guide - Ipland

Catalyst 6500 Series Switches Installation Guide - Ipland

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Removing and Installing the DC-Input Power Supplies<br />

Chapter 4<br />

Removal and Replacement Procedures<br />

Step 8<br />

Connect the source DC cable lugs to the 2700 W power supply terminal block posts (Figure 4-23) in this<br />

order:<br />

• Ground cable lug to the ground terminal posts<br />

• Negative (–) source DC cable lug to terminal post –VE-1<br />

• Positive (+) source DC cable lug to terminal post +VE-1<br />

Note<br />

If you are only going to install one pair of source DC cables (1350 W operation), you can attach<br />

the source DC cables to either the VE-1 or VE-2 pair of terminal posts. Also notice that there is<br />

only one ground connection on the power supply faceplate.<br />

Caution<br />

When you tighten the terminal nuts, make sure that they are snug. Do not overtighten them.<br />

Overtightening the terminal nuts can damage the terminal block. The recommended torque values for<br />

tightening the terminal nuts are 15 inch-pounds (1.7 newton-meters) (minimum) and 20 inch-pounds<br />

(2.2 newton-meters) (maximum).<br />

Figure 4-23<br />

Attaching the Source DC Cables and the Ground Cable<br />

PWR-2700-DC/4<br />

-VE-1<br />

-VE-1<br />

INPUT1 INPUT2 FAN OUTPUT<br />

OK OK OK FAIL<br />

48V-60V 48V-60V<br />

=40A =40A<br />

-VE-2<br />

-VE-2<br />

ALL FASTENERS MUST BE FULLY ENGAGED<br />

PRIOR TO OPERATING THE POWER SUPPLY<br />

270853<br />

Position the source DC cables in the fixed cable guide. Place the top half of the fixed cable guide over<br />

the source DC cables and secure the top half of the cable guide to the bottom half with two screws.<br />

Figure 4-24 shows how the source DC cables are routed from the left side of the power supply.<br />

Warning When installing the unit, always make the ground connection first and disconnect it last. Statement 42<br />

Step 9<br />

Step 10<br />

Route and secure the ground cable to the fixed cable guide loops with the two cable-ties supplied with<br />

the power supply. (See Figure 4-24.)<br />

Position the clear plastic terminal block cover over the terminal block and secure it to the power supply<br />

using the four supplied screws. (See Figure 4-24.)<br />

4-34<br />

<strong>Catalyst</strong> <strong>6500</strong> <strong>Series</strong> <strong>Switches</strong> <strong>Installation</strong> <strong>Guide</strong><br />

OL-5781-08

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!