POISE-SkyLite User Guide - Palmer College of Chiropractic, Intranet ...

CHAPTER 3
NETWORKS AND EMULATIONS
I am in
How I dial from
this location
Dial using
Calling Card
This location has
call waiting
The phone
system at this
location uses
Select your country code from the “I am in” list box.
Fill in the access codes if applicable.
Fill in the field if this is applicable to your location.
If the location you will be dialing from has call waiting facilities,
enable the This Location Has Call Waiting field. You can also set
a code that will disable this facility.
Select the type of phone system your location uses: Tone dialing
or Pulse dialing.
Selecting the modem
To select the type of modem you will use to connect:
Select the modem type from the Connect Using field. If you have no modems, you must
load one. You can do this from the Windows Control Panel by selecting Modems.
Configuring the modem
To configure the modem:
Click the Configure button next to Connect Using.
General:
Set the Port, Speaker volume and Maximum speed.
Connection:
Click on the Connection tab to set the connection settings. Connection preferences you
can set are Data bits, Parity and Stop bits.
Call preferences you can set are:
• Wait for dial tone before dialing.
• Cancel the call if not connected within __ secs.
• Disconnect a call if idle for more than __ mins.
You can click on the Port Settings button to configure port settings.
You can click on the Advanced button to configure the following:
• Error control.
• Flow control.
• Modulation type.
• Extra settings.
• Record a log file.
Click on the Options tab to set:
Connection control:
• Bring up terminal window before dialing.
• Bring up terminal window after dialing.
Dial control:
• Operator assisted or manual dial.
• Wait for credit card tone: __ seconds.
Status control:
• Display modem status.
Click on OK.
POISE-SkyLite User Guide 45