Telemetry Module MT-021 User Manual

&ADMIN#LPHN=6#SMST_6="Mark"#SMSN_6="+48987654321"
Module response:
>#LPHN=6#SMST_6="Mark"#SMSN_6="+48987654321"
Setting HiHi alarm threshold of 1-Wire 2 input to 115:
&ADMIN#OW_ACT_2=2#OW_ALM_HH_2=115
Module response:
>#OW_ACT_2=2#OW_ALM_HH_2=115
Setting new event on seventh position on event list. Event is triggered by crossing
LoLo alarm threshold on analog input AN2:
&ADMIN#EVNO=7#EV_TRIG_7=3#EV_FLAG_7=71#EV_EDGE_7=4
Module response:
>#EVNO=7#EV_TRIG_7=3#EV_FLAG_7=71#EV_EDGE_7=4
Setting module RTC clock to 2010-12-31 23:59:59:
&ADMIN#CRTC="2010-12-31 23:59:59"
Module response:
>#CRTC="2010-06-17 08:27:40"
10.3. Syntax for reading and writing data in SMS mode
Description of SMS command
Internal application of a module is able to receive, process and send short text
messages (SMS). There is a set of command which can be put in SMS message, allowing
the user to read from and write to internal registers placed in module's memory.
Characters with special meaning:
Character
#
Description
starts a command
ATTENTION! putting two hash signs one after another will prevent
module from processing command following it. However after
sending one of hash signs will be deleted - this allows to control
resources of one module from another, e.g. set binary output Q1 to
'1' (##HB128=1)
* starts a macro
> used as first character in SMS text inhibits parsing of SMS
$ used as first character in SMS text inhibits answering to this SMS
79