Telemetry Module MT-021 User Manual

6.2.8.3.8.3. E-mail title
Function - Defines an e-mail title
Data type - text
Range - 0..31 characters
Default value -
Comments -
6.2.8.3.8.4. E-mail text
Function - Defines text of an message
Data type - text
Range - 0..160 characters
Default value -
Comments - Text may contain any string of characters, except
diacritical signs. It may contain mnemonics
dynamically replaced at run-time by values drawn
from the module e.g.: time, register or logical state of
the bit. The syntax of commands is described in detail
in Syntax of commands for reading and writing data
by SMS paragraph.
6.3. Configuration writing
After required modifications and parameter settings, the configuration is stored on
the configuring PC's hard disk only. In order to write it to the module memory, it has
to be transmitted to the module. For local configuration, it is enough to secure a
connection via RS232 cable. Detailed description of local configuration is to be found
in the MTM user manual.
Remote configuration can be realized via SMS commands. It is necessary to enter the
phone number on an authorized list, except for the first configuration of the module.
Detailed description of remote configuration is to be found in the chapter Module
configuration via SMS.
6.4. Verification of configuration
Despite high reliability of both local and remote module configuration, verify of it is
important. It is relevant if the module's behavior does not comply in accordance with
the performed configuration. For verification, please read the configuration from the
module and check parameters settings.
Reading of module configuration is described in details in MTM user manual and
chapter Module configuration via SMS.
64