Telemetry Module MT-021 User Manual

6.2.8.1.8.4. Receiver e-mail address
Function - Allows to enter receiver e-mail address, e.g.
jane.brown@other_company.com
Data type - text
Range - 0..31 characters
Default value -
Comments -
6.2.8.1.8.5. E-mail title
Function - Defines an e-mail title
Data type - text
Range - 0..31 characters
Default value -
Comments -
6.2.8.1.8.6. Message text
Function - Defines text which will be send as an e-mail or SMS
message
Data type - text
Range - 0..160 characters
Default value -
Comments - Messages text may contain any string of characters,
except diacritical signs. It may contain mnemonics
dynamically replaced at run-time by values drawn from
the module e.g.: time, register values or logical state of
bits. Syntax of commands is described in Syntax of
commands for reading and writing data by SMS
paragraph.
6.2.8.2. CLIP calls
The term „CLIP call” describes attempts to establish a phone connection to a defined
number. This connection is not supposed to be picked up by the recipient. Identification
of sending module's phone number is enough to convey the alert. The meaning of alert
should be agreed upon. Notice that recipient does not have to be a GSM network
subscriber but must have a phone able to identify and display caller ID. The function
corresponds to sending 1 bit of information triggered by event occurrence free of
charge. The list of rules holds max. 16 rules allowing to establish a connection with
selected phone number. Adding a new position is done in the context menu by
right-clicking mouse while one of positions on the list is highlighted.
Adding more rules is done by setting the parameter Number of CLIP calls rules to
desired value.
60