Telemetry Module MT-021 User Manual

6.2.6.3.3. Logged information
Function - Defines text of message periodically put in event logger
Data type - text
Range - 0..160 characters
Default value -
Comments - text may contain any string of characters, except
diacritical. It may contain mnemonics dynamically
replaced at run-time by values drawn from the module
e.g.: time, register or logical states of bits. The syntax of
commands is described in detail in Syntax of commands
for reading and writing data by SMS paragraph.
6.2.7. Events
Group Events defines status change of binary inputs (flags, inputs, outputs, bits) as
events. Events are used to trigger recording events logger and sending SMS
messages/CLIP calls or to control relay outputs.
6.2.7.1. Number of events
Function - Defines the number of events in events table.
Data type - number
Range - 0...32
Default value - 0
Comments - If the value is 0, events table is not displayed
6.2.7.2. Name
Function - Defines events user friendly name
Data type - Text
Range - Letters and numerals, max. 15 characters
Default value - EVT1...EVT32
Comments - Entering user-friendly names makes it much easier to
distinguish events source and therefore choosing the
correct event to trigger specific rule or action of module.
6.2.7.3. Trigger source (binary inputs)
Function - defines resource to trigger event
Data type - selection list
Range - None
Inactive event
Binary inputs
Events associated with binary inputs I1 ... I4
Analog inputs
Events associated with analog inputs AN1, AN2
Inputs 1-WIRE
Events associated with 1-WIRE inputs
51