Telemetry Module MT-021 User Manual
Telemetry Module MT-021 User Manual
Telemetry Module MT-021 User Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Default value<br />
Comments<br />
- empty<br />
- Optional parameter used only if required by GSM network<br />
operator<br />
6.2.4.4. <strong>Module</strong> IP<br />
Function<br />
- allows user to define IP number for newly created module<br />
definition and displays IP number read from the module<br />
configuration that was assigned to the module during last login<br />
to GPRS network<br />
Data type<br />
- IP number field<br />
Range - 0.0.0.0 - 255.255.255.255<br />
Default value - 0.0.0.0<br />
Comments - If after reading the configuration or setting device time this<br />
parameter value is different from 0.0.0.0, it means that<br />
module is logged into GPRS network with this particular IP<br />
address assigned to it.<br />
6.2.4.5. GPRS login retry interval [s]<br />
Function<br />
- Defines interval (in seconds) between retries of GPRS logon<br />
attempts after GPRS login failure.<br />
Data type<br />
- number<br />
Range<br />
- 10...3600 [s]<br />
Default value - 10 [s]<br />
Comments -<br />
6.2.4.6. GPRS testing address (ping)<br />
Function<br />
- sets IP address which is used to test GPRS network connection<br />
in case it is lost<br />
Data type<br />
- IP address field<br />
Range - 0.0.0.0 - 255.255.255.255<br />
Default value - 0.0.0.0<br />
Comments - This parameter sets recipient address for ping data frames<br />
testing GPRS transmission channel.<br />
Leaving recipient address at 0.0.0.0 turns off GPRS testing<br />
functionality which is not advised.<br />
6.2.4.7. Idle time [s]<br />
Function<br />
Data type<br />
Range<br />
Default value<br />
Comments<br />
- Defines interval (in seconds) for sending data frame (ping)<br />
testing GPRS network in case it is lost<br />
- number<br />
- 0...21600 [s] (6h)<br />
- 0 [s]<br />
- in case of inactivity longer than the value defined in this<br />
parameter the module sends a control frame in order to check<br />
38