Lantech LGS-1104 User Manual

More documents

Recommendations

Info

Appendix 10 /100BASE-TX Pin outs With10/100BASE-TX cable, pins 1 and 2 are used for transmitting data, and pins 3 and 6 for receiving data. • RJ-45 Pin Assignments Pin Number Assignment 1 Tx+ 2 Tx- 3 Rx+ 6 Rx- [NOTE] “+” and “-” signs represent the polarity of the wires that make up each wire pair. The table below shows the 10 / 100BASE-TX MDI and MDI-X port pin outs. Pin MDI-X Signal Name MDI Signal Name 1 Receive Data plus (RD+) Transmit Data plus (TD+) 2 Receive Data minus (RD-) Transmit Data minus (TD-) 3 Transmit Data plus (TD+) Receive Data plus (RD+) 6 Transmit Data minus (TD-) Receive Data minus (RD-) 10/100Base-TX Cable Schematic The following two figures show the 10/100Base-TX cable schematic. 36
Straight-through cable schematic Cross over cable schematic 10/100/1000Base-TX Pin outs The following figure shows the 10/100/1000 Ethernet RJ-45 pin outs. 37
Page 1 and 2: Lantech LGS-1104 4 10/100/1000T + 1
Page 3 and 4: Content FCC Warning ...............
Page 5 and 6: Introduction The 4 10/100/1000T + 1
Page 7 and 8: Spanning Tree IEEE802.1w rapid span
Page 9 and 10: Rear Panel The rear panel consists
Page 11 and 12: Desktop Installation Set the switch
Page 13 and 14: Two 4 10/100/1000T + 1 Mini-GBIC We
Page 15 and 16: 4. Key in the default password as
Page 17 and 18: failure (The default IP is 192.168.
Page 19 and 20: Statistics-2 (Detailed) The followi
Page 21 and 22: Disable the awareness so that ports
Page 23 and 24: • Click Apply to have the configu
Page 25 and 26: • Hello Time (1-10): The scale of
Page 27 and 28: 802.1X Configuration IEEE 802.1X is
Page 29 and 30: • Or, click Refresh to refresh th
Page 31 and 32: QoS DSCP Mapping interface • Afte
Page 33 and 34: • And then, press Upload to updat
Page 35 and 36: Troubleshooting This section is int
Page 37 and 38: Technical Specification This sectio
Page 39: Operating Humidity 10% to 90% (Non-

Lantech LGS-1104 User Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?