Lantech LGS-1104 User Manual

More documents

Recommendations

Info

System Restart Reboot the switch in software reset. Click Yes to restart the system. System Restart interface Factory Default Reset the switch to default configuration. Click Yes to reset all the configurations to factory default value. Factory Default interface Firmware Upload The system provides the Web GUI firmware upgrade function which allows users to upgrade the switch firmware. • Click Browse... to locate the firmware. 28
• And then, press Upload to update the firmware. Software Upload interface Configuration Upload/Download The system provides the Web GUI configuration file transfer function which would allow user to backup and restore the switch configuration. • Click Browse to locate the file. • And then, press Upload to upload the file. Configuration Upload interface • And then, press Yes to update the loaded file. 29
Page 1 and 2: Lantech LGS-1104 4 10/100/1000T + 1
Page 3 and 4: Content FCC Warning ...............
Page 5 and 6: Introduction The 4 10/100/1000T + 1
Page 7 and 8: Spanning Tree IEEE802.1w rapid span
Page 9 and 10: Rear Panel The rear panel consists
Page 11 and 12: Desktop Installation Set the switch
Page 13 and 14: Two 4 10/100/1000T + 1 Mini-GBIC We
Page 15 and 16: 4. Key in the default password as
Page 17 and 18: failure (The default IP is 192.168.
Page 19 and 20: Statistics-2 (Detailed) The followi
Page 21 and 22: Disable the awareness so that ports
Page 23 and 24: • Click Apply to have the configu
Page 25 and 26: • Hello Time (1-10): The scale of
Page 27 and 28: 802.1X Configuration IEEE 802.1X is
Page 29 and 30: • Or, click Refresh to refresh th
Page 31: QoS DSCP Mapping interface • Afte
Page 35 and 36: Troubleshooting This section is int
Page 37 and 38: Technical Specification This sectio
Page 39 and 40: Operating Humidity 10% to 90% (Non-
Page 41 and 42: Straight-through cable schematic Cr

Lantech LGS-1104 User Manual

Create successful ePaper yourself

Delete template?

Save as template?