Lantech LGS-1104 User Manual

More documents

Recommendations

Info

QoS Configuration interface • Click DSCP Mapping to enter DSCP priority configuration interface. ‣ DSCP [0- 63]: The system provides 0 ~ 63 TOS priority level. When the IP packet is received, the system will check the DSCP level value in the IP packet. For example, port 1 is set as DSCP mode and DSCP level 25 is set as high. When the packet is received via port 1, the system will check the DSCP value of the received IP packet. If the DSCP value of the received IP packet is 25 (priority = high), and then the packet priority will have the highest priority. ‣ Priority: Select the priority level—high, medium, low, or normal • Click Apply to have the configuration take effect. • Or, click Refresh to refresh the configuration to view the newest state. 26
QoS DSCP Mapping interface • After having set mode as ‘vlantag’, click VLAN tag Mapping to enter VLAN tag priority configuration interface. • Set the VLAN tag priority level from 0 ~ 7 for each port. • Click Apply to have the configuration take effect. • Press Refresh to refresh the configuration to view the newest state. QoS VLAN Tag Priority Mapping interface 27
Page 1 and 2: Lantech LGS-1104 4 10/100/1000T + 1
Page 3 and 4: Content FCC Warning ...............
Page 5 and 6: Introduction The 4 10/100/1000T + 1
Page 7 and 8: Spanning Tree IEEE802.1w rapid span
Page 9 and 10: Rear Panel The rear panel consists
Page 11 and 12: Desktop Installation Set the switch
Page 13 and 14: Two 4 10/100/1000T + 1 Mini-GBIC We
Page 15 and 16: 4. Key in the default password as
Page 17 and 18: failure (The default IP is 192.168.
Page 19 and 20: Statistics-2 (Detailed) The followi
Page 21 and 22: Disable the awareness so that ports
Page 23 and 24: • Click Apply to have the configu
Page 25 and 26: • Hello Time (1-10): The scale of
Page 27 and 28: 802.1X Configuration IEEE 802.1X is
Page 29: • Or, click Refresh to refresh th
Page 33 and 34: • And then, press Upload to updat
Page 35 and 36: Troubleshooting This section is int
Page 37 and 38: Technical Specification This sectio
Page 39 and 40: Operating Humidity 10% to 90% (Non-
Page 41 and 42: Straight-through cable schematic Cr

Lantech LGS-1104 User Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?