Lantech LGS-1104 User Manual

More documents

Recommendations

Info

should be considered carefully before applying it. When a proper hash algorithm is used, traffic is kind of randomly decided to be transmitted across either link within the trunk and load balancing will be seen. • Select the group members. Normal means the port is not the trunk member. • Click Apply to have the configuration take effect. • Or, click Refresh to refresh the configuration to view the newest state. Port Trunk interface LACP Setting The Link Aggregation Control Protocol (LACP) is a computer networking term and is part of IEEE specification 802.3ad that allows bundling several physical ports together to form a single logical channel. LACP allows a network switch to negotiate an automatic bundle by sending LACP packets to the peer. LACP is a protocol implementation in OSI layer 2 which controls through which physical links the traffic will be routed. • Protocol Enable: Tick the check box to enable LACP protocol of the port. • Key Value (auto | 1 - 255): The LACP key determines which ports potentially can be aggregated together. 18
• Click Apply to have the configuration take effect. • Or, click Refresh to refresh the configuration to view the newest state. LACP Setting interface LACP Status When the LACP aggregator has been set up, the LACP status information will display as below. 19
Page 1 and 2: Lantech LGS-1104 4 10/100/1000T + 1
Page 3 and 4: Content FCC Warning ...............
Page 5 and 6: Introduction The 4 10/100/1000T + 1
Page 7 and 8: Spanning Tree IEEE802.1w rapid span
Page 9 and 10: Rear Panel The rear panel consists
Page 11 and 12: Desktop Installation Set the switch
Page 13 and 14: Two 4 10/100/1000T + 1 Mini-GBIC We
Page 15 and 16: 4. Key in the default password as
Page 17 and 18: failure (The default IP is 192.168.
Page 19 and 20: Statistics-2 (Detailed) The followi
Page 21: Disable the awareness so that ports
Page 25 and 26: • Hello Time (1-10): The scale of
Page 27 and 28: 802.1X Configuration IEEE 802.1X is
Page 29 and 30: • Or, click Refresh to refresh th
Page 31 and 32: QoS DSCP Mapping interface • Afte
Page 33 and 34: • And then, press Upload to updat
Page 35 and 36: Troubleshooting This section is int
Page 37 and 38: Technical Specification This sectio
Page 39 and 40: Operating Humidity 10% to 90% (Non-
Page 41 and 42: Straight-through cable schematic Cr

Lantech LGS-1104 User Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?